Page 1
Assembly Instruction Sheet #IS-QF1398SMM
6 COR PORATE PA RKWAY
GOO SE CREE K,SC .294 45
www .quo izel. com
Tools Required: Flathead screwdriver, Ph il li ps scr ew dr iv er, pli er s, wir e cutters, wire
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
strippers, electrical ta pe , safety glasses.
Bulb Recommended: (3 ) Medium Base 60W Maximum
Estimated Assembly Time: 20-30 minutes
Preparation: Identify an d inspect all parts before beginning installation. Check package
content li st and dia gr am s below to be sure all parts are present. If any parts are missing
or damaged, do not att em pt to assemble, install, or operate the fixture. Contact cu st om er
service fo r replacement parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
For Style QF1398SMM
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
A
Package Contents
Part
A Crossbar
B
C
D
E
F
G
H
I
Description
Mounting Screw
Lock Washer
Hex Nut
Mounting Ball
Lock Screw
Socket Assembly
Diffuser
Shade
Quantity
1 pc.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
3 pcs.
1 pc.
1 pc.
1 pc.
B
G
C
D
E
F
H
I
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1 of 5
September 2012
Page 2
QF1398SMM
FINISH: MOTTLED SILVER
2.4m m
13Ga
QUOI ZEL
GND
R
5” Dia.
1”
1
12”
3
4”
16” Dia.
2
16” Dia.
(3) 60W Medium
Base Bulbs
(Not Supplied)
PART NUMBER
NO.
11398SMMQF
1
2
3
G3500DI
S1485MC
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE N EA RE ST 1 /2 "
BASE QF1398SMM
DIFFUSER 15"D
SHADE MICA 16"D
REPLACEMENT PART DESCRIPTION
2 of 5
REQ.
1
1
1
Page 3
6 COR PORATE PA RKWAY
GOO SE CREE K,SC .294 45
www .quo izel. com
Assembly Instruction Sheet #IS-QF1398SMM
For Style QF1398SMM
STEP 1 - Attach Shade to Socket Assembly
A. Place the Diffuser (H) in the bottom of the Shade (I).
B. Align the holes on Side Arms to the Mounting Holes on
the top edge of the Shade (I). Secure the Socket
Assembly (G) onto the Shade (I) with Lock Screws (F).
Hand tighten until snug.
STEP 2 - Attach Mounting Screws, Lock
Washers and Hex Nuts to Crossbar
A. Line up a set of holes on the Crossbar (A) and Holes on
the Ceiling Canopy.
B. Thread Mounting Screws (B) into the holes on the
Crossbar (A), pass Lock Washers (C) and thread Hex Nut
(D) onto the Mounting Screws (B). Hand tighten until
snug.
Side Arm
Lock Screw
Shade
Figure 1
Mounting Screw
Lock Washer
Socket
Assembly
Diffuser
Mounting
Hole
Crossbar
Hex Nut
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
Ceiling
Canopy
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
3 of 5
Figure 2
September 2012
Page 4
6 COR PORATE PA RKWAY
GOO SE CREE K,SC .294 45
www .quo izel. com
Assembly Instruction Sheet #IS-QF1398SMM
For Style QF1398SMM
STEP 3 - Attach Crossbar to Outlet Box
A. Attach the Crossbar (A) to Outlet Box and secure by
threading Outlet Box Screws (not supplied) into the
Mounting Holes on the Outlet Box. Tighten until snug.
STEP 4 - Make Wire Connections
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box
to Black Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground
Wire from fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
Figure 3
Outlet
Box
Crossbar
Mounting
Hole
Outlet Box
Screw
White w ire fro m suppl y White w ire fro m fixtu re
Black wire fro m suppl y
(or Red)
Groun d wire fr om supp ly Groun d wire fr om fixt ure
Black wire fro m fixtu re
Figure 5
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
or visit us on-line at www.quoizel.com
4 of 5
Figure 4
September 2012
Page 5
6 COR PORATE PA RKWAY
GOO SE CREE K,SC .294 45
www .quo izel. com
Assembly Instruction Sheet #IS-QF1398SMM
For Style QF1398SMM
STEP 5 - Attach Ceiling Canopy to Mounting
Screw
A. Place the Ceiling Canopy on the Socket Assembly (G)
over the Mounting Screws (B) and secure with Mounting
Balls (E). Hand tighten until snug.
STEP 6 - Install Bulb
A. This fixture uses standard bulb with a standard screw
base. Maximum 60 watts.
B. Insert bulb and screw properly into place.
Your fixture is now assembled and ready to use. Enjoy!
Figure 6
Mounting Screw
Mounting Ball
Ceiling Canopy
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2012 Quoizel Inc.
Figure 7
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
5 of 5
Bulb
Socket
September 2012
Loading...