Page 1
Assembly Instruction Sheet #IS-QF1213SBN
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
,.
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers, wire cutters,wire
strippers,electricaltape,safety glasses.
BulbRecommended: (4) MediumBase100WMaximum
EstimatedAssemblyTime: 20-30minutes
Preparation:Identifyandinspect all partsbeforebeginninginstallation. Check package
contentlistanddiagrams below tobesureall parts arepresent.Ifany parts aremissing
ordamaged,donot attempt toassemble,install,or operate thefixture.Contactcustomer
serviceforreplacementparts.
Warnings and Cautions
For Style QF1213SBN
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
A
Package Contents
F
G
Part
A Crossbar
B
C
D
E
F
G
H
Description
Mounting Screw
Lock Washer
Hex Nut
Mounting Ball
Socket Assembly
Shade
Socket Collar
Quantity
1pc.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
1pc.
4 pcs.
4 pcs.
B
C
D
E
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of5
H
September2011
Page 2
QF1213SBN
FINISH: BRUSHED NICKEL
6" Sq.
2.4mm
13Ga
QUOIZEL
1
GND
R
11"
5"
2
5" Sq.
19" Sq.
(4)100W A19
Medium Base Bulbs
(Not Supplied)
PART NUMBER
NO.
M280KTBN
1
2
G2481SH
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION
KIT BRSH NIKL REPL BB8601-04BN
SHADE OPAL ETCHED GLASS 5"D
2of5
REQ.
1
1
Page 3
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-QF1213SBN
For Style QF1213SBN
STEP 1 - Attach Mounting Screws, Lock
Washers and Hex Nuts to Crossbar
A. Line up a set of holes on the Crossbar (A) and Holes on
the Ceiling Canopy of the Socket Assembly (F).
B. Thread Mounting Screws (B) into the holes on the
Crossbar (A), pass Lock Washers (C) and thread Hex Nut
(D) onto the Mounting Screws (B). Hand tighten until
snug.
STEP 2 - Attach Crossbar to Outlet Box
A. Attach the Crossbar (A) to Outlet Box and secure by
threading Outlet Box Screws (not supplied) into the
Mounting Holes on the Outlet Box. Tighten until snug.
Figure 1
Mounting Screw
Lock Washer
Ceiling
Canopy
Figure 2
Mounting
Hole
Crossbar
Hex Nut
Socket
Assembly
Outlet
Box
Crossbar
Outlet Box
Screw
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
3of5
September2011
Page 4
Assembly Instruction Sheet #IS-QF1213SBN
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
STEP 3 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box
to Black Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground
Wire from fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
White wire from supply White wire from fixture
,.
For Style QF1213SBN
Figure 3
Black wire from supply
(or Red)
Ground wire from supply Ground wire from fixture
Black wire from fixture
Figure 4
STEP 4 - Attach Ceiling Canopy to Mounting
Screw
A. Place the Ceiling Canopy on the Socket Assembly (F)
over the Mounting Screws (B) and secure with Mounting
Balls (E). Hand tighten until snug.
Socket Assembly
Figure 5
Mounting Screw
Ceiling Canopy
Mounting Ball
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of5
September2011
Page 5
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-QF1213SBN
For Style QF1213SBN
STEP 5 - Attach Shade to Socket
A. Place the Shade (G) over the Socket and secure with
the Socket Collar (H). Hand tighten until snug.
STEP 6 Install Bulb-
A. This fixture uses standard bulb with a standard screw base.
Maximum 100 watts.
B. Insert bulb and screw properly into place.
Your lamp semi-flush fixture is now assembled and ready to
use. Enjoy!
Figure 6
Socket
Socket
Socket
Collar
Socket
Bulb
Figure 7
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
5of5
September2011
Loading...