6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
,.
ToolsRequired:Flatheadscrewdriver,Phillips screwdriver,pliers,wire cutters, wire
strippers,electricaltape,safetyglasses.
BulbRecommended: (1) Medium Base 100W Maximum
EstimatedAssemblyTime:20-30 minutes
Preparation:Identifyandinspectallpartsbefore beginning installation. Check package
contentlistanddiagramsbelowto be sure all parts are present. If any parts are missing
ordamaged,donotattempttoassemble, install, or operate the fixture. Contact customer
serviceforreplacementparts.
Assembly Instruction Sheet #IS-Q1560PN
For Style Q1560PN
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Package Contents
Part
A Crossbar
B
C
D
E
F
G
H
I
J
K
L
M
N
O
Description
Mounting Screw
Lock Washer
Hex Nut
Mounting Ball
Fixture Body
Harp
Finial
Shade
Self-tapping Screw
Wall Anchor
Cord Cover Backplate
Cord Cover
Plug Insert
Short Mounting Screw
Quantity
1pc.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
1pc.
1pc.
1pc.
1pc.
5 pcs.
5 pcs.
1pc.
2 pcs.
1pc.
2 pcs.
A
B
C
D
E
F
G
H
I
L
J
K
M
N
O
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of7
August2013
Q1560PN
FINISH: PALLADIAN BRONZE
26”
2
GND
2.4mm
13Ga
QUOIZEL
12” Dia.
6” Dia.
R
8.5”
6”
18”
1
6”
(1)100W Medium
Base Bulb
(Not Supplied)
PART NUMBER
NO.
1
2
11560PNQ
S1502CR
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION
BASE PALLADIAN BRONZE Q1560PN
SHADE ROUND BELL CREAM 6"X12"X7.50”
2of7
REQ.
1
1
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
For Wall Mount Portable
Assembly Instruction Sheet #IS-Q1560PN
For Style Q1560PN
STEP 1 Mark Points on the Wall-
A. Attach the Crossbar (A) onto the desired location on the
wall surface. Mark two points on the wall surface from
the holes on the Crossbar (A) that you would like to
pass Self-tapping Screws (K).
STEP 2 Install Mounting Screw-
A. Thread the Short Mounting Screws (O) into the holes on
the Crossbar (A). Pass the Lock Washers (C) over the
Short Mounting Screws (O)
onto the screws. Hand tighten until snug.
and thread the Hex Nuts (D)
Crossbar
Mark
Self-tapping
Screw
Figure 1
Crossbar
Lock Washer
Hex Nut
Short Mounting
Screw
STEP 3 Install Inner Backplate-
A. Drill proper holes for Wall Anchors (J) on the marked
points on the wall surface.
B. Insert the Wall Anchors (J) into the drilled holes on the
wall surface. Attach the Crossbar (A) onto the wall
surface. Secure by threading Self-tapping Screws (K)
into the Wall Anchors (J). Hand tighten until snug.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
or visit us on-line at www.quoizel.com
3of7
Figure 2
Figure 3
Mark
Wall Anchor
Crossbar
Self-tapping
Screw
August2013
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-Q1560PN
For Style Q1560PN
STEP 4 - Attach Fixture Body to Mounting
Screw
A. Place the Backplate of the Fixture Body (F) over the
Short Mounting Screw
(O) and secure with Mounting
Balls (E). Hand tighten until snug.
Short Mounting Screw
Backplate
STEP 5 Attach Cord Cover Backplate and
-
Cord Cover
AL
. Locate the Cord Cover Backplate ( ) To position the Cord
Cover Backplate ( ) measure approx 12 ½ inches down
from the base of the Backplate Mark the points from the
holes on the Cord Cover Backplate ( ) for Wall Anchors ( ).
B. Using a portable hand drill, drill proper holes from the marks
in the wall surface for the Wall Anchors (K) Locate the
Wall Anchors (K) and place into the holes in the wall surface
C. Place the Cord Cover Backplate (L) and match the holes with
the Wall Anchors (K) Secure it by threading the Self-tapping
Screws (J) into the Wall Anchors (K) Hand tighten until snug.
D. Position the Supply Wire inside of the Cord Cover Backplate
(L) so that it will not be pinched. Locate the Cord Cover (M)
and secure it to the Cord Cover Backplate (L) by pressing it
over the Backplate.
L
.
.
."
.
LK
.
.
.
Figure 4
Mounting Ball
Backplate
12 ½”
Figure 5
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Wall Anchor
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of7
Cord Cover
Self-tapping Screw
Cord Cover Backplate
Supply Wire
with Plug End
August2013
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-Q1560PN
For Style Q1560PN
STEP 6 - Install Harp
A. Install the Harp (G) by pressing the ends of the Harp
(G) into the Harp Clips as shown.
STEP 7 Assemble Shade-
A. Place the Shade (I) over the top end of the Harp (G) and
secure with the Finial (H). Hand tighten until snug.
Figure 6
Harp
Harp Clip
Fixture Body
Finial
Shade
Harp
STEP 8 Install Bulb-
A. This fixture uses standard bulb with medium screw
base. Maximum 100 watts.
B. Insert bulb and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
or visit us on-line at www.quoizel.com
Figure 7
Bulb
Socket
Figure 8
August2013
5of7
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
For Fixed Wall Mount
Assembly Instruction Sheet #IS-Q1560PN
For Style Q1560PN
STEP 9 - Install Mounting Screw
A. Thread the Mounting Screws (B) into the holes on the
Crossbar (A). Pass the Lock Washers (C) over the
Mounting Screws (B) and thread the Hex Nuts (D) onto
the screws. Hand tighten until snug.
STEP 10 Install Inner Backplate to Outlet Box-
A. Refer to Step 2 to complete the mounting screw
installation.
B. Attach the Crossbar (A) to Outlet Box and secure by
threading Outlet Box Screws (not supplied) into the
Mounting Holes on the Outlet Box. Tighten until snug.
Mounting
Hole
Mounting Screw
Crossbar
Hex Nut
Lock Washer
Figure 9
Outlet
Box
Crossbar
Outlet Box
Screw
Figure 10
STEP 11 Make Wire Connections-
A. Pull out the Supply Wire with Plug End and cut down it,
left 6” cord for the Wire Connection.
B. Insert Plug Insert to cover the Exiting Hole as shown.
C. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
D. Connect White Supply Wire from the Outlet Box to
Ribbed side from fixture.
E. Connect Black (or Red) Supply Wire from the Outlet Box
to Smooth side from fixture.
F. Twist connectors until wires are tightly joined together.
G. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
White wire from supply
Black wire from supply
(or Red)
Figure 12
Ribbed side
from fixture
Smooth side
from fixture
Plug Insert
Figure 11
Exiting Hole
Supply Wire
with Plug End
Figure 13
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
6of7
August2013
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-Q1560PN
For Style Q1560PN
STEP 12 - Attach Fixture Body to Mounting
Screw
A. Place the Backplate of the Fixture Body (F) over the
Mounting Screws (B) and secure with Mounting Balls
(E). Hand tighten until snug.
B. Install harp as step 6.
C. Assemble Shade as step 7.
D. Install bulb as step 8.
Your fixture is now assembled and ready to use. Enjoy!
Backplate
Mounting Screw
Mounting Ball
Figure 14
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
7of7
August2013
Loading...