Quoizel PLR1716PN User Manual

Page 1
6 CORPORATE PARKWAY GOOSE CREEK SC 29445 www quoizel com
..
Quoizel, Inc. 6 Corporate Parkway Goose Creek, SC 29445
Customer Service Phone 631.273.2700 Fax 631.231.7102 www.quoizel.com
,.
Assembly Instruction Sheet #IS-PLR1716PN
For Style PLR1716PN
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wire cutters, wire
strippers,electricaltape,safety glasses.
BulbRecommended: (3) MediumBase100WMaximum EstimatedAssemblyTime: 20-30minutes
Preparation:Identifyandinspect all partsbeforebeginninginstallation. Check package
contentlistanddiagrams below tobesureall parts arepresent.Ifany parts aremissing ordamaged,donot attempt toassemble,install,or operate thefixture.Contactcustomer serviceforreplacementparts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Package Contents
A
Part
A Crossbar
B
E
F
G
I
J
K
L
Description
Mounting Screw
Lock Washer
Hex Nut
Mounting Ball
Steel Collar
Glass Shade
Socket Assembly
Organza Shade
Socket Collar
Socket Collar Tool
Lock Screw
Quantity
1pc.
1pc.
1pc.
2 pcs.
1pc.
3 pcs.
3 pcs.
1pc.
1pc.
3 pcs.
1pc.
3 pcs.
B
E
F
G
J K
I
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of5
L
September2013
Page 2
PLR1716PN
FINISH: PALLADIAN BRONZE
5.5” Dia.
4.5” Dia. 1”
2.4mm 13Ga
QUOIZEL
GND
R
14.5”
6”
14.5” Dia.
3.5” Dia.
1
5”
2
16” Dia.
(3)100W Medium
Base Bulbs
(Not Supplied)
PART NUMBER
NO.
1
2
G3694SH
S1547OH
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION
ETCHED GLASS SHADE 3.5"D
ORGANZA HARDBACK SHADE 16"D
2of5
REQ.
3
1
Page 3
6 CORPORATE PARKWAY GOOSE CREEK SC 29445 www quoizel com
..
,.
Assembly Instruction Sheet #IS-PLR1716PN
For Style PLR1716PN
STEP 1 Install Organza Shade-
A. Place the Organza Shade (I) from the top of the Socket
Assembly (H). Attach the Mounting Tabs in the bottom edge of the Organza Shade (I) onto the Tabs on the Side Arms. Secure the shade by threading the Lock Screws (L) into the Mounting Tabs. Hand tighten until snug with screwdrivers.
STEP 2 Install Glass Shade-
A. Place the Glass Shade (G) and Steel Collar (F) over the
Socket and secure by using Socket Collar Tool (K) threading the Socket Collar (J) onto the Socket. Hand tighten until snug.
Organza
Shade
Mounting Tab
Tab
Lock Screw
Side Arm
Organza Shade
Socket Assembly
Figure 1
Socket Collar Tool
Socket Collar
Steel Collar
Shade
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
3of5
Socket
Figure 2
Side Arm
September2013
Page 4
6 CORPORATE PARKWAY GOOSE CREEK SC 29445 www quoizel com
..
,.
Assembly Instruction Sheet #IS-PLR1716PN
For Style PLR1716PN
STEP 4 - Attach Crossbar to Outlet Box
A. Secure the Crossbar (A) to the outlet box with outlet
box screws (not supplied). Tighten until snug.
STEP 5 Attach Nipple to Crossbar-
A. Thread one Hex Nut (D) onto the top end of the Nipple
(B).
B. Place one Lock Washer (C) over the top end of the
Nipple (B) and then thread the Nipple (B) into the center lock hole of the Crossbar (A).
C. Using pliers, thread the hex Nut (D) against the
Crossbar (A) and hand tighten until snug.
Figure 4
Mounting Hole
Outlet Box
Crossbar
Outlet Box Screw (not Supplied)
Figure 5
Crossbar
Lock Washer
Hex Nut
Nipple
STEP 6 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.) Strip and prepare wire ends according to instructions supplied with connectors.
B. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box
to Black Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground
Wire from fixture. E. Twist connectors until wires are tightly joined together. F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
White wire from supply
Black wire from supply
(or Red)
Ground wire from supply
Figure 7
White wire from fixture
Black wire from fixture
Ground wire from fixture
Figure 6
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of5
September2013
Page 5
6 CORPORATE PARKWAY GOOSE CREEK SC 29445 www quoizel com
..
,.
Assembly Instruction Sheet #IS-PLR1716PN
For Style PLR1716PN
STEP 7 - Attach Ceiling Canopy to Mounting
Screw
A. Thread another Hex Nut (D) onto the end of the Nipple
(B). B. Place the Ceiling Canopy over the Mounting Screws (B)
and secure with the Mounting Ball (E). Hand tighten
until snug.
STEP 8 - Install Bulb
A. This fixture uses standard bulb with medium screw
base. Maximum 100 watts. B. Insert bulb and screw snugly into place.
Figure 8
Nipple
Hex Nut
Ceiling Canopy
Mounting Ball
Bulb
Socket
Your fixture is now assembled and ready to use.
Enjoy!
Figure 9
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2013 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
5of5
September2013
Loading...