Quoizel MQ8701HL User Manual
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
FIGURE1
OUTLET BOX
,.
UNIVERSAL
CROSSBAR
INSTALLATION INSTRUCTIONS:
(2) OUTLET
BOX SCREWS
(not supplied)
HANGER
CRYSTAL
CAP
SOCKET
CANDLE
COVER
1. Before beginning installation, carefully unpack and identify all parts
referring to illustration FIGURE 1.
2. Turn the electrical power to installation point OFF at circuit breaker.
Locate the UNIVERSAL CROSSBAR and secure to OUTLET BOX with
(2)OUTLET BOX SCREWS(not supplied).
3. (Quoizel recommends 2 people for this step)Use
Make the connections:
wire connectors (not supplied) connect the HOUSE GROUND to the
FIXTURE GROUND WIRE attach the HOUSE WHITE WIRE to FIXTURE
;
WHITE (or RIBBED SIDE) SUPPLY WIRE; connect the HOUSE BLACK (or
RED) WIRE to the FIXTURE BLACK (or SMOOTH SIDE) WIRE. Wrap each
connection with approved electrical tape.
4. Carefully tuck all wires into the WALL MOUNTED OUTLET BOX and
position the fixture over the outlet box. Align the HOLES in the BACK
PLATE with the (2) MOUNTING SCREWS attached to the UNIVERSAL
CROSSBAR. Pass the fixture over the (2)MOUNTING SCREWS and
secure against by threading (2)MOUNTING BALLS onto end of screw.
Tighten until snug.
5. Position CAP onto top end of CANDLE COVER. Install bulb(s) referring to
fixture marking and /or labels for maximum wattage.
(2) MOUNTING SCREWS
GREEN GROUND SCREW
FIXTURE SUPPLY WIRE
and GROUND WIRE
BACK PLATE
(2)MOUNTING
BALL(S)
CRYSTAL
HANGER
6.Locate CRYSTALS onto HANGERS.
CRYSTALS Please refer to the illustration to locate them
..
Note There are 2 kinds of
:
7. Restore power to the installation point ON. Retain this sheet
for future reference.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
IS-MQ8701
12.05
Loading...