Quoizel MQ1720HL User Manual

ASSEMBLY/ INSTALLATION INSTRUCTIONS

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

..

UNIVERSAL CROSSBAR

(2)OUTLET BOX SCREWS

SCROLLED PART

,.

(not supplied)

HEX NUT

SHADE

HEX NUT

FINIAL

(2)MOUNTING SCREWS

SUPPLYWIRES and GROUND WIRE

FIXTURE CANOPY

(2)MOUNTING BALLS

SOCKET
CLUSTER

HEX COUPLING

CENTER STEM

PLAIN WASHER

SHADE STOP

CAP

SMALL TUBE

DECORATION
ARM

HANGER

CRYSTAL

1 Before beginning the installation carefully unpack and identify all parts referring

., ,

to the illustration

2 Turn the electrical power to installation point OFF at circuit breaker

..

3 Unfold DECORATION ARMS to proper locations

..

4 Locate the 2 MOUNTING SCREWS and thread them intothe back of the

.

UNIVERSALCROSSBAR making sure that they match the holes in the FIXTURE

CANOPY Using 2 OUTLET BOX SCREWS not supplied fasten the

.() ( ),

UNIVERSAL CROSSBAR to the OUTLET BOX

5 Using wire connectors not supplied connect the

.

Making the wire connections

HOUSE GROUND WIRE to the FIXTURE GROUND WIRE connect the HOUSE
WHITE WIRE to the FIXTURE SUPPLY WIRE WHITE or RIBBED SIDE
connect the HOUSE BLACK or RED WIRE to the FIXTURE SUPPLY WIRE

BLACK or SMOOTH SIDE Wrap each connection with approved electrical tape

(). .

6 Carefully tuck all of the wiring up into the outlet box and fit the FIXTURE

.,

CANOPY over the MOUNTING SCREWS Secure the FIXTURE CANOPY to the
ceiling with the 2 MOUNTING BALLS making sure that the balls arefully

threaded onto the MOUNTING SCREWS before tightening

.

()

,

.

:()

;

();

()

.

() ,

.

7. Thread the beaded end of the CENTER STEM into the HEX COUPLING underside of
the SOCKET CLUSTER. Hand tighten until snug. Proceed to thread one HEX NUT
onto the end of the CENTER STEM and adjust it to proper location to make sure

there is enough length left for the rest components.

8

.

Install the correct bulbs referring to fixture markings and or labels for maximum

wattage

.

/

9. Place the PLAIN WASHER, the SHADE and the SHADE STOP over the end of the
CENTER STEM in turn. Secure them together with the HEX NUT. Proceed to locate
the CAP, the SCROLLED PART and the SMALLTUBE over end of the CENTER STEM.
Thread the FINIAL onto the end of the CENTER STEM and hand tighten until snug to

secure them.

10. Hang the CRYSTALS onto the FINIAL and the end of the DECORATIVE ARMS.

CRYSTAL

Restore power to installation point ON Retain this sheet for future reference

...

11

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!

IS-MQ1720

Revised 2007-05-04