6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
. .
, .
INSTRUCTION SHEET IS LP1717STYLE NUMBER LP1717IB:
PACKAGE CONTENTS
Part
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
Lock Washer (for #8-32 Screw)
Description
Crossbar
Green Ground Screw
Mounting Screw
Hex Nut (for #8-32 Screw)
Mounting Ball
Spacer Tube
Nipple with Hex Nut
Check Ring
Flat Washer
Rubber Washer
Hex Nut (1/8IP)
Cap
Center Column
Decorative Chain
Decorative Ring
Shade
Finial
Quantity
1pc
1pc
2pcs
2pcs
2pcs
2pcs
1pc
1pc
1pc
1pc
1pc
1pc
1pc
1pc
3pcs
1pc
1pc
1pc
Revised 2008-11-11
A
N
B
C
O
D
E
F
G
H
I
J
K
L
M
R
P
Q
!
WARNINGS AND CAUTIONS
WARNING:
● Befo re beginning the in stal la tion, tu rn off el ectricity at th e circuit breaker box or the ma in fuse box by
switching off the circuit breaker or removing the fuse.
CAUTIONS:
● These instructions are provided for your safe ty. It is very i mportant t hat they a re read completely before
the installation of your fixture. We strongly recommend that a professional electrician install the fixture.
● Di sconnect fixture from t he power source before replacing t he bulb( s), ma king sure t he bulb(s) had
sufficient time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may
result.
PREPARATION
● Befo re beginning in st allation of prod uct, make sure a ll parts are present. Comp ar e parts with p ac kage
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for replacement part.
● Estimated Assembly Time : 30 45 minutes
● Tools R equi red for Assembly (not included): F lath ea d screwdriver Phillips screwdriver, pliers, electrical
tape, wire cutters, safety glasses &3, 100 Watt, Type A Medium Base Bulbs.
● He lp ful Tools (not included): Wire Strippers.
,
-
1 OF 3
INSTALLATION INSTRUCTIONS
STEP 1:
a Thread the Nipple into the Hex Coupling underside of the
.
Socket Cluster. Using plier, thread the Hex Nut against the
Hex Coupling and hand tighten until snug.
STYLE NUMBER LP1717IB:
Socket
Assembly
STEP 2:
a Locate top ends of Decorative Chains onto Hooks on the
.
side of the Ceiling Canopy as shown.
b. Lift the Decorative Ring upward and locate the Hooks on it
onto the bottom ends of the Decorative Chains.
Nipple with
Hex Nut
Wheel Part
Decorative
Ring
Hex Coupling
Ceiling
Canopy
Hook
Decorative
Chain
Hook
STEP 3:
a Locate the following components over the end of the
.
Nipple in turn:
Spacer Tube, Check Ring, Rubber Washer, Shade and Flat
Washer.
b. Thread the Hex Nut (1/8IP) onto the end of the Nipple and
tighten until snug to secure the above parts.
c. Locate the Cap over the end of the Nipple and secure with
the Finial. Hand tighten until snug.
Rubber Washer
Hex Nut (1/8IP)
Fixture Pan
Nipple
Spacer Tube
Check Ring
Shade
Flat Washer
Cap
2 OF 3
Finial
INSTALLATION INSTRUCTIONS
STYLE NUMBER LP1717IB:
STEP 4:
a Screw the Mounting Screws into the Crossbar place the
. ,
Lock Washers over the Mounting Screws and thread the
Hex Nuts onto the Mounting Screws as shown Secure the
.
position of the Mounting Screws by tightening the Hex
Nuts against the Crossbar
b Secure the Crossbar to the Outlet Box with Outlet Box
.
Screws
.
.
STEP 5:
* ( )
Use Wire Connectors not supplied to connect the
.
wires
.
a Connect the House Ground Wire to the Fixture Ground
Wire.
. ( )
b Connect the House White or Ribbed Wire to the
Fixture Supply Wire White or Ribbed Side .
. ( )
c Connect the House Black or Red Wire to the Fixture
Supply Wire Black or Smooth Side
.
d Wrap each connection with approved electrical tape and
( ).
carefully stuff all of the connected wires into the Outlet
.
Box
( )
Mounting Screw
Outlet Box
WHITE OR RIBBED
FROM HOUSE
BLACK OR RED WIRE( )
FROM HOUSE
GROUND WIRE GROUND WIRE
FROM HOUSE FROM FIXTURE
Crossbar
Lock Washer
Outlet Box Screw
WHITE OR RIBBED
FROM FIXTURE
BLACK OR SMOOTH
FROM FIXTURE
Hex Nut
STEP 6:
.a Place Ceiling Canopy onto Outlet Box aligning 2 holes in
the Backplate with 2 Mounting screws threaded on the
Crossbar and secure it against wall with Mounting Balls
.
Mounting Screw
Mounting Ball
STEP 7:
a Install correct bulbs referring to fixture markings and or labels for maximum wattage. / .
. . .Your installation is completed now Restore electricity Retain this sheet for future reference
Crossbar
Ceiling Canopy
3 OF 3
Loading...