Page 1
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
,.
Assembly Instruction Sheet #IS-LLA1615RA
For Style LLA1615RA
ToolsRequired:Flatheadscrewdriver,Phillips screwdriver,pliers,wirecutters,wire
strippers,electricaltape,safetyglasses.
BulbRecommended: (3) Candelabra Base Bulbs 60W Maximum
EstimatedAssemblyTime:20-30 minutes
Preparation:Identifyandinspectallpartsbeforebeginninginstallation.Checkpackage
contentlistanddiagramsbelowtobesureallpartsarepresent.Ifanypartsaremissing
ordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomer
serviceforreplacementparts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Package Contents
A
Part
A Crossbar
B
C
D
E
F
G
Description
Mounting Screw
Lock Washer
Hex Nut
Mounting Ball
Fixture Body
Finial
Quantity
1pc.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
1pc.
1pc.
B
C
D
E
G
F
Need assistance with partsor assembly? Call Quoizelcustomer service at 1-631-273-2700
2014 Quoizel Inc.
Thank you for purchasinga Quoizel product.
or visit us on-lineat www.quoizel.com
1of5
July2014
Page 2
LLA1615RA
FINISH: RUSTICANTIQUE BRONZE
15” Dia.
8.5” Dia.
GND
2.4mm
13Ga
QUOIZEL
R
14.5”
(3) 60W Candelabra
Base Bulbs
(Not Supplied)
PART NUMBER
NO.
1
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION
2of5
REQ.
Page 3
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-LLA1615RA
For Style LLA1615RA
STEP 1 - Attach Mounting Screws, Lock
Washers and Hex Nuts to Crossbar
A. Unscrew the Knurled Nut on the bottom center of the
Fixture Body (F). Remove the Cap and move down the
Cage to proper location.
B. Line up a set of holes on the Crossbar (A) and Holes on
the Ceiling Canopy. Thread Mounting Screws (B) into the
holes on the Crossbar (A), pass Lock Washers (C) and
thread Hex Nut (D) onto the Mounting Screws (B). Hand
tighten until snug.
Mounting Screw
Lock Washer
Ceiling
Canopy
Cage
Crossbar
Hex Nut
Fixture Body
STEP 2 - Attach Crossbar to Outlet Box
A. Attach the Crossbar (A) to Outlet Box and secure by
threading Outlet Box Screws (not supplied) into the
Mounting Holes on the Outlet Box. Tighten until snug.
Figure 1
Figure 2
Mounting
Hole
Cap
Knurled Nut
Outlet
Box
Crossbar
Outlet Box
Screw (not
supplied)
Need assistance with partsor assembly? Call Quoizelcustomer service at 1-631-273-2700
2014 Quoizel Inc.
Thank you for purchasinga Quoizel product.
or visit us on-lineat www.quoizel.com
3of5
July2014
Page 4
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-LLA1615RA
For Style LLA1615RA
STEP 3 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box
to Black Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground
Wire from fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
White wire from supply White wire from fixture
Figure 3
Black wire from supply
(or Red)
Ground wire from supply Ground wire from fixture
Black wire from fixture
Figure 4
STEP 4 - Attach Ceiling Canopy to Mounting
Screw
A. Place the Ceiling Canopy on the top of the Fixture Body
(F) over the Mounting Screws (B) and secure with
Mounting Balls (E). Hand tighten until snug.
Ceiling Canopy
Fixture Body
Figure 5
Mounting
Screw
Mounting
Ball
Need assistance with partsor assembly? Call Quoizelcustomer service at 1-631-273-2700
2014 Quoizel Inc.
Thank you for purchasinga Quoizel product.
or visit us on-lineat www.quoizel.com
4of5
July2014
Page 5
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
STEP 5 Install Bulb-
,.
Assembly Instruction Sheet #IS-LLA1615RA
For Style LLA1615RA
A. This fixture uses candelabra bulb with a screw base.
Maximum 60 watts.
B. Insert bulb and screw properly into place.
STEP 6 Secure the Cage-
A. Lift up the Cage until it is flush to the Ceiling Canopy. Place
the Cap back onto the bottom of the Cage and secure with
the Knurled Nut. Hand tighten until snug.
B. Thread the Finial (G) onto the nipple on the bottom center of
the Fixture Body (F). Hand tighten until snug.
Your fixture is now assembled and ready to use. Enjoy!
Bulb
Socket
Figure 6
Ceiling Canopy
Fixture Body
Fixture Body
Finial
Cage
Nipple
Figure 7
Need assistance with partsor assembly? Call Quoizelcustomer service at 1-631-273-2700
2014 Quoizel Inc.
Thank you for purchasinga Quoizel product.
or visit us on-lineat www.quoizel.com
5of5
July2014
Loading...