Quoizel HCE8411IB User Manual

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

..

,.

INSTALLATION INSTRUCTIONS

1. Before beginning the installation, carefully unpack and identify all parts
referring to illustration.

,

UNIVERSAL
CROSSBAR

OUTLET BOX

(2) MOUNTING SCREWS

GREEN GROUND SCREW

FIXTURE SUPPLY WIRE
and GROUND WIRE

(2) OUTLET
BOX SCREWS
(not supplied)

FIXTURE COVER

BACKPLATE

(2)MOUNTING BALLS

SOCKET

GLASS PANEL

2. Turn the electrical power to installation point OFF at circuit breaker.

3 Postion GLASS PANELS inside of CAGE. Lift CAGE with GLASS upward

.

and align the holes on top edge of CAGE with mounting holes on the bottom
edge of FIXTURE COVER. Secure them together by threading LOCK
SCREWS onto the mounting holes on the FIXTURE COVER. Hand tighten
until snug.

4. Locate the UNIVERSAL CROSSBAR and secure to OUTLET BOX with

(2)OUTLET BOX SCREWS(not supplied).

5. (Quoizel recommends 2 people for this step)

Make the connections:

Use wire connectors(not supplied)connect the HOUSE GROUND to the

FIXTURE GROUND WIRE attach the HOUSE WHITE WIRE to FIXTURE

;

WHITE (or RIBBED SIDE) SUPPLY WIRE; connect the HOUSE BLACK
(or RED) WIRE to the FIXTURE BLACK (or SMOOTH SIDE) WIRE. Wrap
each connection with approved electrical tape.

6. Carefully tuck all wires into the WALL MOUNTED OUTLET BOX and
position the fixture over the outlet box. Align the HOLES in the

BACKPLATE with the (2) MOUNTING SCREWS attached to the
UNIVERSAL CROSSBAR. Pass the fixture over the (2)MOUNTING
SCREWS and secure against by threading (2)MOUNTING BALLS onto
end of screw. Tighten until snug.

7. Install bulb(s) referring to fixture markings and/or labels for maximum

wattage.

IS HC8406

-

Page1of2
2006 10-12

-

LOCK SCREW

CAGE

8. Refer to Page 2 for fixture caulking instructions.

9. Restore power to the installation point ON. Retain this sheet for future

reference.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

..

,.

EXTERIOR GRADE
CAULK

WALL SURFACE MOUNTED OUTDOOR FIXTURE
CAULKING INSTRUCTIONS

With the OUTDOOR FIXTURE properly installed in accordance with supplied
assembly/installation instructions, proceed with caulking instructions below.

Note: Be sure EXTERIOR WALL SURFACE and FIXTURE BACKPLATE are free to dirt to
caulking. Using EXTERIOR GRADE CAULK, start on one side of FIXTURE BACKPLATE and
follow contour, were the FIXTURE BACKPLATE meets the EXTERIOR WALL SURFACE
upward. Proceed to caulk over top of backplate and down other side.

BOTTOM OF FIXTURE BACKPLATE

to ensure proper moisture drainage.

DO NOT CAULK

OUTDOOR
FIXTURE BACKPLATE

EXTERIOR WALL SURFACE

IS HC8406

-

Page2of2
2006-10-12