Quoizel HCE8409IB User Manual

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

..

OUTLET BOX

,.

CROSSBAR

(2) OUTLET BOX SCREWS
(not supplied)

BACKPLATE

(2)MOUNTING
BALLS

INSTALLATION INSTRUCTIONS

1. Before beginning the installation, carefully unpack and identify all parts referring
to the illustration.

2 Turn the electrical power to installation point OFF at circuitbreaker

..

3.

Slip down the GLASS PANELtotheinsideoftheCAGE. Locate the TABSontothe

top edge of the GLASS PANELandmatchtheholesonthemwiththemounting
holes on the top edge of the CAGE. Use screw driver,threadtheLOCKSCREWS
into the mounting holes and hand tighten until snug to secure the GLASS PANEL.

(2) MOUNTING SCREWS

FIXTURE SUPPLYWIRE

and GROUND WIRE

FIXTURE HOOD

LOCK SCREW

TAB

GLASS PANEL

LOCK SCREW

SOCKET

4.Install the bulb referring to fixture markings and/or labels for maximum wattage.

5.Lift the CAGE with GLASS PANELS upward to attach the bottom of the FIXTURE
HOOD and make the holes on the top edge of the CAGE match the mounting holes
on the bottom of the FIXTURE HOOD. Secure them together with the LOCK
SCREWS. Hand them until snug with screw driver.

6.

Place the CROSSBAR on the BACKPLATE and align the holes in the BACKPLATE
with a set of threaded holes in the CROSSBAR. Install the (2) MOUNTING
SCREWS in the aligned threaded holes on the CROSSBAR. Next, mount the
CROSSBAR to the outlet box with (2)OUTLET BOX SCREWS (not provided).

6. Make the connections: Usewireconnectors(notsupplied)connect theHOUSE
GROUND to the FIXTURE GROUND WIRE attach the HOUSE WHITE WIRE to

;

FIXTURE WHITE (or RIBBED SIDE) SUPPLY WIRE; connect the HOUSEBLACK
(or RED) WIRE to the FIXTURE BLACK(or SMOOTH SIDE)WIRE. Wrapeach
connection with approved electrical tape.

7. Carefully tuck all wires into the WALLMOUNTED OUTLET BOX and position the
fixture over the outlet box.Align the HOLES in the BACKPLATEwith the

2 MOUNTING SCREWSattached to the UNIVERSAL CROSSBAR. Pass the

()

fixture over the 2 MOUNTING SCREWS and secure against by threading

2 MOUNTING BALLS onto end of screw. Tighten until snug.

()

()

8. Refer to Page 2 for fixture caulking instructions.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!

CAGE

9 Restore power to the installation point ON. Retain this sheet for future reference.

.

IS HC8409

-

Page1of2
2007-02-28

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

..

,.

EXTERIOR GRADE
CAULK

WALLSURFACEMOUNTED OUTDOOR FIXTURE
CAULKING INSTRUCTIONS

With the OUTDOOR FIXTURE properly installed in accordance with supplied
assembly/installation instructions, proceed with caulking instructions below.

Note: Be sure EXTERIOR WALLSURFACE and FIXTURE BACKPLATEare free to dirt to
caulking. Using EXTERIOR GRADE CAULK, start on one side of FIXTURE BACKPLATE and
follow contour,were the FIXTURE BACKPLATEmeets the EXTERIOR WALLSURFACE
upward. Proceed to caulk over top of backplate and down other side.

BOTTOM OF FIXTURE BACKPLATE

to ensure proper moisture drainage.

DO NOT CAULK

OUTDOOR
FIXTURE BACKPLATE

EXTERIOR WALL SURFACE

IS HC8409

-

Page2of2
2007-02-28