Quoizel GT8980IB User Manual

6 CORPORATE PARKWAY
GOOSE CREEK, SC. 29445

ASSEMBLY / INSTALLATION
INSTRUCTIONS

1. Before beginning carefully and identify all parts referring to
Figure 1 and Figure 2.

FIGURE 1.

Note: Generic backplate illustration

CROSSBAR WITH
GROUND SCREW

FIXTURE
SUPPLY WIRES
AND GROUND

FIXTURE
BACKPLATE

FIGURE 2.

LOCK BALL

LOCK BALL

FIXTURE
COVER

2. (Refer to Figure 1) Turn power to the installation point OFF.
Locate and secure CROSSBAR to the wall mounted OUTLET
BOX with (2) OUTLET BOX SCREWS (not supplied).

3. Make the connections: (Quoizel recommends (2) people
for the next 2 steps. Position the fixture in front of outlet box.
Connect the HOUSE GROUND wire and the FIXTURE
GROUND wire to UNIVERSAL CROSSBAR using GROUND
SCREW (green); using wire connectors (not supplied),
connect the HOUSE WHITE WIRE to the FIXTURE WHITE
WIRE; connect the HOUSE BLACK (or RED) WIRE to the
FIXTURE BLACK WIRE. Make sure there are no exposed
wires.

4. Carefully tuck in all wiring into the OUTLET BOX and position
the FIXTURE over the (2) MOUNTING STUDS. Pass the
studs through the (2) MOUNTING HOLES on the fixture
BACKPLATE. Locate (2) LOCK BALLS and thread onto
ends of studs. To secure FIXTURE to wall, tighten balls until
snug

5. Install bulb referring to fixture markings and / or labels for
maximum wattage.

6. Locate SHADE ASSEMBLY and pass the (2) MOUNTING
STUDS at top through the (2) MOUNTING HOLES in
FIXTURE COVER. Thread LOCK BALLS onto studs to
to secure shade. Hand tighten until snug.

7. Refer to enclosed IS-727 for weather proofing instructions.

MOUNTING
STUD

8. Restore power to the installation point ON. Retain this sheet
for future reference.

SHADE
ASSEMBLY

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!

IS-896

11.01