Quoizel DH8801AN User Manual
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
INSTALLATION INSTRUCTIONS
1.Before beginning the installation, carefully unpack and identify all parts
referring to the illustration.
FIXTURE SUPPLYWIRE
and GROUND WIRE
(2)OUTLET BOX SCREWS
(not supplied)
SHADE
LOCK BALL
OUTLET BOX
SOCKET
HEX NUT
STUD
METALTAB
RUBBER
WASHER
HEX NUT
BACKPLATE
SCREW
SHADE
SUPPORT
STRAP
SCREW
SIDE ARM
2.Turnthe power to the installation point OFF at circuit breaker.
3. Position the hole on the bottom of the SHADE over the SCREW inside of the
SHADE HOLDER. Locate the RUBBER WASHER over the SCREW and
thread the HEX NUT onto the SCREW to secure them. Hand tighten until snug.
4. .
Quoizel recommend 2 people for this step
Thread the HEX NUTS onto the SCREWS. Locate the BACKPLATE inside of
the SHADE and match the holes on the SHADE SUPPORTSTRAPwith the
holes on the side of SHADE. Position the SCREWS with the HEX NUTS
through the holes from inside of the SHADE. And then locate the SIDEARMS.
Make the holes on them over the STUDS on the side of the SHADE HOLDER
and the SCREWS extruding from the side of the SHADE. Secure them
together by threading LOCK BALLS onto the SCREWS and the STUDS. Hand
tighten until snug.
5. :
Make the wiring connections
Using wire connectors(not supplied), connect the HOUSE GROUND WIRE
to the FIXTURE GROUND WIRE; connect the HOUSE WHITE WIRE to the
FIXTURE WHITE(or RIBBED) WIRE; connect the HOUSE BLACK(or RED)
WIRE to the FIXTURE BLACK(or SMOOTH) WIRE. Wrap each connection
with approved electrical tape.
6. Proceed to secure the BACKPLATE to the wall mounted outlet box by using
(2)OUTLET BOX SCREWS(not supplied). Prior to this, determine how many
METALTABS will need to be removed from the backplate in order to align the
BACKPLATE with the mounting holes on the outlet box.Toremove the METAL
TABS, use a flat head screw driver to apply pressure from the backside of the
BACKPLATE. Once the METALTAB moves forward, remove with pliers.
7. Install bulb referring to fixture markings and/or labels for maximum wattage.
LOCK BALL
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
SHADE HOLDER
8. Restore the power to the installation point ON. Retain this sheet for future
reference.
IS DH8801
-
2007-02-22
Loading...