Quoizel CTL1717GK User Manual
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
INSTRUCTION SHEET IS-CTL1717
STYLE NUMBER: CTL1717GK
PACKAGE CONTENTS
PART
A Crossbar
B
C
D
E
F
G
H
I
J
DESCRIPTION
Green Ground Screw
Mounting Screw
Small Lock Washer
Small Hex Nut
Mounting Ball
Lock Ball
Fixture Assembly
Shade
Ring
QUANTITY
1pc
1pc
2pcs
2pcs
2pcs
2pcs
3pcs
1pc
1pc
1pc
ISSUED 08-2010 REVISED 2010-09-27
A
B
C
D
E
F
G
H
I
J
WARNINGS AND CAUTIONS
WARNING:
● Before beginning the installation, turn off electricity at the circuit breaker box or the main fuse box by switching
off the circuit breaker or removing the fuse.
CAUTION:
● These instructions are provided for your safety. It is very important that they are read completely before the
installation of your fixture. We strongly recommend that a professional electrician install the fixture.
● Disconnect fixture from the power source before replacing the bulb(s), making sure that bulb(s) had sufficient
time to cool down. DO NOT subject the lamp to any shock while lit as shattering of lamp may result.
PREPARATION
● Before beginning installation of product, make sure all parts are present. Compare parts with package contents
list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or operate the
product. Contact customer service for replacement part.
● Estimated Assembly Time: 30 - 45 minutes
● Tool Required for Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape,
Wire cutter, Safety glasses and (3) 100W A19 Medium Base Bulbs.
● Helpful Tools (not included): Wire strippers.
1OF3
INSTALLATION INSTRUCTIONS
STYLE NUMBER: CTL1717GK
STEP 1:
a. Place the Shade seating onto the Ring as shown..
b. Lift the Ring with Shade upward. Pass the holes on the
Tabs of the Ring through the Bolts on the ends of Side
Arms. Secure by threading the Lock Balls onto the
Bolts. Hand-tighten until snug.
STEP 2:
a. Screw the Mounting Screws into the Crossbar place
the Lock Washers over the Mounting Screws and
thread the Hex Nuts onto the Mounting Screws as
shown Secure the position of the Mounting Screws by
.
tightening the Hex Nuts against the Crossbar
b. Secure the Crossbar to the Outlet Box with Outlet Box
Screws
.
,
.
Tab
Shade
Ring
Mounting Screw
Fixture Assembly
Side Arm
Bolt
Lock Ball
Crossbar
Hex Nut
Lock Washer
STEP 3:
a. Locate the Ceiling Canopy onto the Crossbar and slip
the Button Stop on the end of Lanyard into the Slot on
the Crossbar as shown.
Outlet Box
Outlet Box Screw
Crossbar
Slot
Button Stop
Lanyard
Ceiling Canopy
2OF3
Loading...