Quoizel CSE9010EK, CSE9010PN Assembly Instruction Sheet
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-CSE9010_R1
For Styles CSE9010PN and CSE9010EK
Pleasegoto forproductcleaning tips. Go tothe selection.
ToolsRequired: Flathead screwdriver,Phillips screwdriver,pliers, wire cutters, wirestrippers,electrical tape, safetyglasses.
LightSource:
EstimatedAssembly Time:
Preparation:
present.Ifany parts are missingordamaged, do not attempttoassemble, install, or operatethefixture. Contact customer serviceforreplacement
parts.
www.quoizel.com Care+Maintenance
(1)MediumBase 150W bulb Maximumor
(1)MediumBase Vintage Bulb isrecommendedbut not supplied.
30-45minutes
Identifyandinspect all parts beforebeginninginstallation. Check package contentlistand diagrams below tobesure all parts are
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Mounting
Screw
A
x3
Finial
B
x1
Water Proof
C
Washer
x1
Lock
Washer
D
x1
Shade
x1
F
G
Fixture
Body
x1
E
Nipple
x1
STEP 2 Install Shade, Fixture
Hood and Bulb to Fixture Body
A. Pass Lock Washer (D), Fixture
B. Insert bulb and screw snugly into
C. Place Shade (G) into Fixture
-
Hood and Water Proof Washer
(B) over the Nipple (E), secure
by threading Finial (B) onto
Nipple (E). Hand tighten until
sung.
place.
Body (F) properly. Then Place
the Fixture Hood onto the top
edge of the Fixture Body (F) and
secure with Lock Screws.
Tighten until snug.
C
D
B
Lock
Screw
Fixture
Hood
E
G
Vintage Bulb
(recommended
but not supplied)
STEP 1 remove Fixture
Hood, Shade and Styrofoam
from Fixture Body
A. Remove Fixture Hood by
B. Remove the Package
-
unlock Lock Screw from
Fixture Body (G).
Material and Shade inside
the Fixture Body (G).
Figure 1
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2017 QuoizelInc.
Lock Screw
Fixture
Hood
Shade
Package
Material
B
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
STEP 3 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Post
1of2
Figure 2
Post
Lighting
Marking Pen
Mounting
Hole
Figure 4
F
Fixture
Fitter
Post
RevisedDate:2017-10-25
STEP 4 M C
EM H
A. Remove the light fixture. Using
STEP 5 Drill Holes-
A. Using the 1/16” bit and drill, drill a pilot hole completely through the
- arking the enter of
ach ounting ole
the center punch and hammer
marking the center of each
mounting hole location that is
marked with the marking pen.
Center Punch
post at each (3) locations marked in step 4 above.
1/16” bit and drill
Hammer
Marking
Figure 4
Post
CSE9010PN
FINISH: PALLADIAN BRONZE
CSE9010EK
FINISH: EARTH BLACK
10” Dia.
7” Dia.
10.5”
17.25”
Figure 5
STEP 6 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from outlet box
Black wire from
outlet box (or Red)
Bare, or Green
Ground wire
from outlet box
STEP 7 Attach the fixture to the Post Mount-
A. Place the fixture on the post lining up the mounting holes on the
fixture fitter with the holes on the post. Use the Mounting Screws (A)
to attach the fixture to the post.
Post
White wire
from fixture
Black wire
from fixture
Ground wire
from fixture
Figure 6
Your fixture is now assembled and ready to use.
Enjoy!
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
Figure 7
2017 QuoizelInc.
Post
Lighting
Fixture
Fitter
A
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
Mounting
Hole
Post
Hole
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
2of2
RevisedDate:2017-10-25
Loading...