Quoizel CAR8730AC User Manual
Assembly Instruction Sheet #IS-CAR8730AC
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
,.
Tools Required: Flatheadscrewdriver, Phillipsscrewdriver, pliers,wirecutters, wire
strippers,electricaltape,safety glasses.
BulbRecommended: (4) CandelabraBase60WMaximum
EstimatedAssemblyTime: 20-30minutes
Preparation:Identifyandinspect all partsbeforebeginninginstallation. Check package
contentlistanddiagrams below tobesureall parts arepresent.Ifany parts aremissing
ordamaged,donot attempt toassemble,install,or operate thefixture.Contactcustomer
serviceforreplacementparts.
Warnings and Cautions
For Style CAR8730AC
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Package Contents
Part
A Crossbar
B
C
D
E
F
H
Description
Mounting Screw
Lock Washer
Hex Nut
Mounting Ball
Top Scroll Assembly
Strut MemberG
Fixture Body
Quantity
1pc.
2 pcs.
2 pcs.
2 pcs.
2 pcs.
1pc.
1pc.
1pc.
A
F
B
C
D
E
G
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of7
H
November2011
CAR8730AC
FINISH: AGED COPPER
Q UO IZE L
2.0mm 14Ga
GND
14Ga
2.0mm
5”
(4)60W Candelabra
base bulbs
(not Supplied)
27.5”
18”
11”x11” SQ.
12.5”
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
PART NUMBER
NO.
REPLACEMENT PART DESCRIPTION
2of7
REQ.
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-CAR8730AC
For Style CAR8730AC
STEP 1 Attach Top Scroll Assembly and
-
Strut Member to Fixture Body
A. Prior to assembly, remove the Fixture Cover from the
Top Scroll by unscrewing the Lock Ball. Unscrew the
Half Lock Ball and remove the Hex Nut, Nipple and Lock
Washer.
B. Locate the Strut Member (G) to the top of the Glass
Frame and thread the nipple protruding from the bottom
of the Fixture Cover into the Hex Coupling on the top of
the Glass Frame. Hand tighten until snug to secure
Strut Member (G).
C. Attach the large scroll end of the Top Scroll onto the top
end of the Fixture Cover and secure with the Lock Ball.
Attach the small scroll end of the Top Scroll to the
Backplate and line up holes on them.
D. Thread the Hex Nut onto the Nipple. Pass the Lock
Washer over the Nipple and then place the Nipple
through the holes on the Backplate and Top Scroll.
Thread the Half Lock Ball onto the Nipple and hand
tighten until snug to secure the Top Scroll.
Hex Nut
Nipple
Backplate
Top Scroll Assembly
Strut Member
Fixture Body
Half Lock
Ball
Lock Washer
Top Scroll
Lock
Ball
Fixture
Cover
Strut
Member
Hex
Coupling
STEP 2 - Attach Mounting Screws, Lock
Washers and Hex Nuts to Crossbar
A. Line up a set of holes on the Crossbar (A) and Holes on
the backplate of the Fixture Body (H).
B. Thread Mounting Screws (B) into the holes on the
Crossbar (A), pass Lock Washers (C) and thread Hex
Nut (D) onto the Mounting Screws (B). Hand tighten
until snug.
Crossbar
Mounting
Screw
Figure 2
Figure 1
Lock Washer
Glass
Frame
Hex Nut
Fixture
Body
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 Quoizel Inc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
3of7
November2011
Loading...