6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
,.
Assembly Instruction Sheet #IS-ALZ1618PN
For Style ALZ1618PN
ToolsRequired: Flathead screwdriver,Phillips screwdriver,pliers, wire cutters,wire
strippers,electrical tape, safetyglasses.
BulbRecommended: (3)Medium Base 60WMaximum
EstimatedAssemblyTime:20-30 minutes
Preparation:Identify and inspectallparts before beginninginstallation.Check package
contentlist and diagramsbelowto be sureallparts are present.Ifany parts aremissing
ordamaged, do notattemptto assemble, install,oroperate the fixture.Contactcustomer
servicefor replacement parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Package Contents
Part
A Crossbar
B
C
D
E
F
G
H
I
J
K
L
M
Description
Nipple
Lock Washer
Hex Nut
Small Flat Washer
Hex Coupling
Big Flat Washer
Rubber Washer
Ceiling Canopy
Shade
Cap
Finial
Stem
Quantity
1pc.
1pc.
2 pcs.
3 pcs.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
1pc.
A
B
C
D
E
F
G
H
K
L
M
I
J
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 QuoizelInc.
Thank youfor purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
1of6
September2011
ALZ1618PN
FINISH: PALLADIAN BRONZE
GND
2.4mm
13Ga
QUOIZEL
R
5"
7.5"
(3)60W Medium
Base Bulbs
(Not Supplied)
16" Dia.
18.5" Dia.
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
PART NUMBER
NO.
REPLACEMENT PART DESCRIPTION
2of6
REQ.
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-ALZ1618PN
For Style ALZ1618PN
STEP 1 - Attach Crossbar to Outlet Box
A. Secure the Crossbar (A) to the outlet box with outlet
box screws (not supplied). Tighten until snug.
STEP 2 Attach Nipple to Crossbar-
A. Locate the Nipple (B) and thread one Hex Nut (D) onto
it about half way. Slip a Lock Washer (C) onto it and
thread one end of the Nipple (B) into the center hole of
the Crossbar (A).
B. Position the Ceiling Canopy (I) over the outlet box,
passing the mounting hole in the center of the Ceiling
Canopy (I) over the end of Nipple (B).
C. Adjust the Nipple (B) so approx38inchoftheNipple
(B) is protruding from the mounting hole. This
adjustment may take a few tries.
D. When this length is achieved, remove the Ceiling
Canopy (I) and tighten the Hex Nut (D) up against the
underside of the Crossbar (A) with pliers.
Figure 1
Mounting
Hole
Figure 2
Ceiling Canopy
Outlet Box
Crossbar
Outlet Box
Screw (not
Supplied)
Crossbar
Lock Washer
Hex Nut
Nipple
STEP 3 Attach Ceiling Canopy-
A. Thread one Hex Nut (D) onto the other end of the nipple
(B). Thread this Hex Nut (D) on just enough so the
inside surface of the Ceiling Canopy (I) rests against it.
* You may have to trial fit the Ceiling Canopy (I) one
more times to insure this distance also. This Hex Nut
(D) is needed here to prevent you from crushing down
the center of the Ceiling Canopy (I).
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 QuoizelInc.
or visit us on-line at www.quoizel.com
3of6
Figure 3
Ceiling
Canopy
Crossbar
Nipple
Hex Nut
September2011
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-ALZ1618PN
For Style ALZ1618PN
STEP 6 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Outlet Box to White
Wire from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box
to Black Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground
Wire from fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
White wire from supply White wire from fixture
Figure 4
Black wire from supply
(or Red)
Ground wire from supply Ground wire from fixture
Black wire from fixture
Figure 5
STEP 5 Attach Ceiling Canopy-
A. Position the Ceiling Canopy (I) to the ceiling by passing
the Nipple (B) through the center hole.
B. Slip on the Small Flat Washer (E) and the Lock Washer
(C) and then thread the Hex Coupling (F) to the bottom
end of the Nipple (B). Snug down assembly until the
Ceiling Canopy (I) is flush against the ceiling.
* Be sure that there are no trapped or pinched wires
along the edge of the Ceiling Canopy (I).
Ceiling
Canopy
Small Flat
Washer
Figure 6
Crossbar
Nipple
Lock Screw
Hex Coupling
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 QuoizelInc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
4of6
September2011
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-ALZ1618PN
For Style ALZ1618PN
STEP 6 Attach Center Stem to Socket
-
Assembly
A. Thread the beaded end of the Center Stem (M) to the
Hex Coupling underside of the Ceiling Canopy (I). Hand
tighten until snug.
STEP 7 - Install Bulb
A. standard bulb with a medium screw
This fixture uses
base 0
. Maximum 6 watts.
B. Insert bulb and screw snugly into place.
Hex Coupling
Bulb
Ceiling Canopy
Center Stem
Figure 7
Socket
Figure 8
STEP 9 - Install Shade
A. Place the Shade (J), the Rubber Washer (H) and the Big
Flat Washer (G) over the end of the Center Stem (M) in
turn. Secure by threading the Hex Nut (D) onto the Center
Stem (M). Hand tighten until snug.
Shade
Rubber Washer
Hex Nut
Center Stem
Big Flat Washer
Figure 9
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 QuoizelInc.
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
5of6
September2011
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
..
,.
Assembly Instruction Sheet #IS-ALZ1618PN
For Style ALZ1618PN
STEP 10 Attach Cap-
A. Place the Cap (K) over the Center Stem (M) extruding
from the Shade (J). Secure by threading the Finial (L) onto
the Center Stem (M). Hand tighten until snug.
Your fixture flush mount lamp is now assembled and ready
to use. Enjoy!
Center Stem
Cap
Finial
Shade
Figure 10
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
2011 QuoizelInc. September2011
or visit us on-line at www.quoizel.com
6of6
Loading...