NFC- Development-Kit
Manual
Please note:
This development kit is only for users with advanced knowledge of computer and
programming. Only the tool “NFC-Manager” can be used easily.
NFC Entwickler Kit, Conrad Best.-Nr.: 001082694
2
NFC Development Kit
Parts list:
1 pc. QDE-Dragon-U
1 CD-ROM NFC-Manager SDK with all tools, drivers, documents and samples
5 pc. TAG-NTAG-20-PVC-WH-AD-TOM, 20mm round NTAG 203 NFC tags
5 pc. CARD-DES-ISO-PVC, Desfire 4k ISO-Card
5 pc. KEYFOB-MF1K-03ABS-BU, Mifare 1k keyfob
Dragon is contact-less Smartcard reader which supports14443 TYPE-A/B, Mifare series, Felica and
NFC (ISO18092)protocol at the same type. It also supports Contact cards (1 X SIM type slots) which
comply with ISO 7816 for secured data transmission. Dragon is available as USB interface.
Description
RF Field : Place contactless card here
LED : Power supplying & operating status
SIM type SAM slots (1ea) are backside of the device when you
open the case. (OPTION)
Version: 1.0
3
Smart Card Interface
Contactless Smart Card (ISO 14443 A/B), MIFARE, FeliCa,
NFC Tag type 1,2,3,4
1 SIM slot for SAM Card (OPTION - ISO7816, T=0,T=1)
Host Interface
USB 2.0 Full Speed (12Mbps) as default /
RS232 (Optional, contact to DUALi for more information)
Host Communication
PC/SC or Vendor Protocol (must be decided with order)
CPU
ARM 32-bit Cortex-M3(48MHz)
128Kbytes Flash, 20Kbytes SRAM
Baud rate
106/212/424/848kbps
Up to 424kbps for NFC P2P mode
Reading Distance
Max 5cm (depends on tag size and performance)
Input Voltage
5V (USB Bus powered)
Current
MAX 200mA
Connection
Direct USB Cable
Size
62(W) * 95(L) * 13(H)mm
Indicator
4 LEDS
Case
ABS
Antenna Matching
Direct matching
Operating Temperature
-10~60 °C
Storage Temperature
-20~80 °C
NFC Development Kit
Hardware Specification
Version: 1.0
4
4 LEDs
USB Connector
Antenna
PN512 RF IC
SAM Socket (SAM1)
(ST-ARM 32-bit
Cortex-M3)
CPU
Smart Card Socket
NFC Development Kit
The block diagram of Dragon
Description of Function
Installation:
Please follow the Installation Driver Guide (CD-Rom-Folder: QUIO NFC Manager SDK/Install Driver)
Tool NFC-Manager: Please start NFC-Manager.exe at the folder NFC-Manager
All protocols and samples can be found on the CD-Rom.
Note: At delivery status the reader works with CCID-Firmware. If you want to read and write RFIDCards with the tool DUALCARD, you have to change the firmware against the VENDOR typefirmware, using the tool DEDOWNLOADER.
Warning and Notice
- For indoor use only.
- This product is affected by metallic elements or magnetism. Please take precautions.
- This device is not waterproof.
Version: 1.0
Loading...