Page 1
Wireless Calling System
Model : LM - T910
Model : LM - T910
Page 2
Call Button
Clear Button
LED Lamp
Case
2. Setting of Group ID
The Transmitter's Group ID must be the same as Receiver's Group ID.
No.1
No.9
No.2
No.10
No.3
No.11
No.4
No.12
No.5
No.13
No.6
No.14
No.7
No.15
No.8
No.16
Page 3
1) If push to Call SW, call number ID of transmitter will be
transmitted to receiver.
And the Receiver will be indicated call number ID.
2) If clear indicated Call number in Receiver,
push to Clear SW, call number ID of transmitter
will be clear the call number of Receiver.
And will be indicated call number ID of Receiver
will be clear.
60 x 60 x 18 mm
3.5 Kg
Page 4
Page 5
** USER INFORMATION
Acknowledging Special Precautions and the FCC Industry Canada Notice
Cautions
Modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
FCC compliance Information
When used the This device complies with part 15 of FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received.
Including interference that may cause undesired operation.
Information to User
This equipment has been tested and found to comply with the limits for a ClassBdigital
device, Pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio Frequency energy and,ifnot
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turningtheequipmentoffandon,theuser is
encouraged to try to correct the interference by one or more of the followingmeasures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
.
Loading...