Quasar Science Q25R, Q100R, Q25WRGBX, Q50R, Q50WRGBX Quick Start Manual

Linear LED

Download Full Manual at

QUASARSCIENCE.COM/RAINBOW

Q-Rainbow RGBX

Quick Start Guide

2000k-6000k Crossfade White Light

with RGB Color Mixing (RGBX)

Wireless by _

DMX over Cat5

Manual Interface with OLED Screen

Universal AC Power 90v-256v

DC Battery Option 10v-26v

Lead / Follow Mode

On Board Effects

Lengths: 2’ 4’ 8’

|

QUASAR SCIENCEQUASAR SCIENCE

OLED Screen

DMX IN DMX OUT

10-26v

DC

DC Power Port

2.1mm x 5.5mm

DMX IN

over Cat5

DMX Out

over Cat5

Cat5 to DMX Adapter

(Not Included)

Enter/Set Right / +Left / -

Receiving Data
Wireless DMX

Link/ Pair

-

+

DMX

Data

Controls

S

S

Rainbow Layout

True 1 Power

Connector

AC Power Switch

in every Rainbow

Wireless DMX

-

+

DMX

Data

DC Power Port

OLED Screen

with Manual Controls

S

S

Linear LED

Q-Rainbow RGBX

Main Menu - Manual Mode

> Intensity

> Color Temp

> CT Preset

> Saturation

> Hue

> +/- Green

> Color Preset

> Effects

> Config

0 to 100%

2000k to 6000k by 100k increments

3200-4000-5000-5600-6000-2000-2800

0 to 100%

0° to 360°

100M to 0G to 100G

Blue-Cyan-Green-Red-Yellow-Orange-Magenta

Rainbow-Short Circuit-Paparazzi-Fire1-Fire2-Fire3-Coplight1-Coplight2-Demo

DMX Address-DMX Profile-Lead/Follow/Wireless On/Off-StatusLights On/Off

-FirmwareVersion-Lamp Hours-Reset to Default-BACK to Main Menu

Main Menu - Manual Mode

> DMX Address

> Profile

> Lead /Follow

> Wireless

> Status Lights

> Firmware

> Lamp Hours

> Reset to Default

001 to 508 (Does not allow address to be outside of 512)

1:HSIC-8 bit, 2:HSIC-16 bit, 3:HSI-8 bit, 4: XFade with CC-8 bit, 5: XFade-8 bit,

-6: CCT & RGB-8 bit, 7: CCT & RGB-16 bit, 8: RGB-8 bit

Lead-Follow1-Follow2-Follow3-Follow4-Follow5

On/Off - Disables the wireless transceiver

On/Off - Turns off the status lights for use on camera

Displays the Firmware Version on the Lamp

Displays the Hours the lamp has been powered on

Sets the lamp back to all its default values

Config Menu

To Set the Intensity, Color Temp, +/- Green, Saturation and Hue:

Press the Left or Right arrows until desired function is selected.

Press Enter to Select.

The selection carrots > < will move from the >Function< to the >Value<

Press the or buttons to set the value. Press Enter to Save.

To Link a Rainbow lamp to a transmitter,

Go to Config->Wireless, Set to ON, Config->Status Lights to ON

If the Wireless DMX is flashing, press and hold the Link button to Unpair.

On the DMX Transmitter, tap the Link button to Pair.

The Wireless DMX Light will start to Flash and turn solid once paired.

-

+

-

+

Getting Started

-

+

DMX

Data