QXS 12G Site Planning Guide, 6-68655-01 Rev B, September 2019, Product of USA.
Trademark Statement:
Artico, Be Certain (and the Q brackets design), DLT, DXi, DXi Accent, DXi V1000, DXi V2000, DXi V4000,
DXiV-Series, FlexTier, Lattus, the Q logo, the Q Quantum logo, Q-Cloud, Quantum (and the Q brackets design),
the Quantum logo, Quantum Be Certain (and the Q brackets design), Quantum Vision, Scalar, StorageCare,
StorNext, SuperLoader, Symform, the Symform logo (and design), vmPRO, and Xcellis are either registered
trademarks or trademarks of Quantum Corporation and its affiliates in the United States and/or other countries.
All other trademarks are the property of their respective owners. Products mentioned herein are for
identification purposes only and may be registered trademarks or trademarks of their respective companies. All
other brand names or trademarks are the property of their respective owners. Quantum specifications are
subject to change.
Your right to copy this manual is limited by copyright law. Making copies or adaptations without prior written
authorization of Quantum Corporation is prohibited by law and constitutes a punishable violation of the law.
This section provides general information for the following chassis:
• QXS-312 12G: 12-Drive System (2-Port: FC or iSCSI)
• QXS-324 12G: 24-Drive System (2-Port: FC or iSCSI)
Chapter 1
Chassis with Bezels Installed
The front of the 12 and 24-drive chassis are 2U high (3.5 inches/88.9mm) and use the same bezel
(2U). Refer to Figure 1 for images of the chassis with bezels installed.
Figure 2 provides images of the front of the 12 and 24-drive chassis with the bezels removed.
Figure 2 Chassis Front View (Bezel Removed)
1 QXS-312 12G: 12-Drive Chassis
•2U high
• 12 drives installed (Labeled 0-11)
• 2-host ports per controller
NOTE: The QXS-312 12G and QXS-324 12G systems ship with drives installed.
2 QXS-324 12G: 24-Drive Chassis
•2U high
• 24 drives installed (Labeled 0-23)
• 2-host ports controller
QXS-412 12G and QXS-424 12G Chassis
This section provides general information for the following chassis:
• QXS-412 12G: 12-Drive System (4-Port: FC or iSCSI)
• QXS-424 12G: 24-Drive System (4-Port: FC or iSCSI)
Chassis with Bezels Installed
The front of the 12 and 24-drive chassis are 2U high (3.5 inches/88.9mm) and use the same bezel
(2U). Refer to Figure 3 for images of the chassis with bezels installed.
Figure 4 provides images of the front of the 12 and 24-drive chassis with the bezels removed.
Figure 4 Chassis Front View (Bezel Removed)
1 QXS-412 12G: 12-Drive Chassis
•2U high
• 12 drives installed (Labeled 0-11)
• 4-host ports per controller
NOTE: The QXS-412 12G and QXS-424 12G systems ship with drives installed.
QXS-484 12G Chassis
This section provides general information for the QXS-484 12G, 84-Drive System (4-Port: FC or iSCSI).
Chassis with Bezels Installed
The front of the 84-drive chassis is 5U high (8.75 inches/222.25mm) and uses a bezel for each drawer.
Refer to Figure 5 for images of the chassis with bezels installed for Drawer 0 and Drawer 1.
2 QXS-424 12G: 24-Drive Chassis
•2U high
• 24 drives installed (Labeled 0-23)
• 4-host ports controller
Figure 5 System Front View (with Bezel)
1
2
1 Drawer 02 Drawer 1
QXS System and Cabinet Information3
Chassis with Drawers Open
0/42
2/44
1/43
3/45
4/46
5/47
6/48
7/49
8/50
9/51
10/52
11/53
12/54
13/55
14/56
15/57
16/58
23/65
18/60
19/61
20/62
21/63
22/64
41/83
17/59
25/67
26/68
27/69
28/70
29/71
30/72
31/73
24/66
37/79
38/80
35/77
39/81
33/75
34/76
36/78
40/82
32/74
NOTE: The QXS-484 12G systems ship with no drives installed (weight). Drives are shipped within
two boxes containing 42 drives within each box.
Figure 6 provides an image of the 84-drive chassis (drive slots view) with the drawer open. There are
a total of 84 drive slots in the two drawers.
• Drawer 0 has drive slots 0-41 (42 drives can be installed)
• Drawer 1 has drive slots 42-83 (42 drives can be installed)
NOTE: Figure 6 displays the front of the drawer on the left side of the illustration (callout 1). The
back of the drawer is on the right side of the illustration (callout 3).
Figure 6 84-Drive Chassis (Drive Slots)
2
1
1 Drawer 0/1 Front2 Drawer 0/1 Left Side
3 Drawer 0/1 Rear (slides into chassis)4 Drawer 0/1 Right Side
4
3
4QXS 12G Site Planning Guide
General Cabinet Information
12
3
4
This section includes the following information:
• Standard Cabinet
• Cabinet Height
• Cabinet Vertical Support Rails
• Cabinet Configurations with Chassis and Drives
Standard Cabinet
Figure 7 provides an image of a standard cabinet which includes locations of the following:
• Front door
• Rear door
• Vertical support rails
• Air vent
Figure 7 Standard Cabinet
1 Front door2 Rear door
3 Vertical support rails4 Air vent
QXS System and Cabinet Information5
Standard features of the cabinet include:
• Front and rear door that can be closed and locked
• Vertical rails, with mounting holes, to allow installation of storage
• 40U high cabinet and 19 inches/48.3cm wide
• Four rolling coasters/wheels
• Four leveling pads (bottom of cabinet)
• A stabilizing foot (after installation of permanent location)
• Access for storage cabling
• AC or DC power source (2 each)
WARNING! Risk of bodily harm and/or injury. Comply with the following:
• Always populate the cabinet from bottom to top to prevent tipping.
• If a cabinet must be moved, use adequate personnel and/or a forklift to relocate the cabinet.
• Push the cabinet from the front when moving.
• A fully populated cabinet can weigh almost 3000 pounds (1360.777kg).
• Cabinets are hard to move, even on a flat surface/floor.
• If moving a cabinet on an incline, always remove the top-half storage arrays/devices to prevent
from tipping.
NOTE: Install the applicable storage rack on the cabinet support rails, then install the
chassis/expansion storage unit, and then populate the unit with applicable drives (HDDs or SSDs).
Ensure to place the cabinet in a location that allows sufficient space to maintain and service (remove
and replace parts) the applicable units within the cabinet.
Cabinet Height
Cabinets heights might vary. A common cabinet is 40U high.
• A height of 1U equals 1.75-inches (44.45-mm).
• So, a 40U cabinet will have 70 inches (1778 mm/1.778 km) of storage space.
6QXS 12G Site Planning Guide
Figure 8 provides a standard cabinet identifying components (callouts) in the front and rear of the
1
2
3
4
5
6
7
8
9
10
1112
1
2
3
2
8
unit. Callout descriptions are provided below the illustration.
Figure 8 Front and Rear View of Cabinet
1 Ventilation cover2 Cable access opening
3 Rear plate4 Support rails
5 Vertical support rails6 Mounting rails
7 Stability foot8 Leveling feet (variable adjust)
9 Power distribution10 AC power entry boxes
11 Front of cabinet12 Rear of cabinet
Cabinet Vertical Support Rails
The cabinet vertical support rails can contain square holes, round holes, or pre-tapped holes. Refer to
the
QXS 12G Hardware Installation and Maintenance Guide
Cabinet Configurations with Chassis and Drives
Ta bl e provides the maximum number of chassis and maximum number of drives that can be installed
within a standard 40U cabinet configuration.
for rackmount installation information:
QXS System and Cabinet Information7
NOTE: Configurations depend on customer requirements. Refer to QXS-312/324/412/424/484 12G
Chassis Supported Configurations on page 8 for RAID chassis and expansion chassis maximum
combinations.
Ta b le 3Cabinet Configurations
Chassis TypeMaximum Chassis in CabinetMaximum Drives in Cabinet
Ta bl e 4 identifies the supported QXS-312/324/412/424/484 12G RAID chassis supported
configurations. Each system configuration (RAID chassis and expansion chassis) can only contain a
specific number of chassis and drives.
Ta b le 4QXS-312/324/412/424/484 12G RAID Chassis with Supported Expansion Chassis
Drive
Expansion
Chassis
Drive Form
Factor Per
Chassis
2U12 Expansion
Chassis
2U24 Expansion
Chassis
5U84 Expansion
Chassis
8QXS 12G Site Planning Guide
QXS-312 12G
RAID Chassis
Attach
12-drives (3.5”
LFF)
Up to 3Up to 9Up to 3Up to 9N/A
Up to 3Up to 9Up to 3Up to 9N/A
N/AUp to 3N/AUp to 3Up to 3
QXS-412 12G
RAID Chassis
Attach
12-drives (3.5”
LFF)
QXS-324 12G
RAID Chassis
Attach
24-drives (2.5”
SFF)
QXS-424 12G
RAID Chassis
Attach
24-drives (2.5”
SFF)
QXS-484 12G
RAID Chassis
Attach
84-drives (2.5”
SFF or 3.5” LFF)
Ta b le 4QXS-312/324/412/424/484 12G RAID Chassis with Supported Expansion Chassis (continued)
Drive
Expansion
Chassis
Intermix 2U
QXS-312 12G
RAID Chassis
Attach
QXS-412 12G
RAID Chassis
Attach
QXS-324 12G
RAID Chassis
Attach
QXS-424 12G
RAID Chassis
Attach
QXS-484 12G
RAID Chassis
Attach
Up to 3Up to 9Up to 3Up to 9N/A
Expansion
Chassis
Note: The 2U12 and 2U24 expansion chassis can be intermixed. However, mixing the 2U12/2U24 expansion
chassis and 5U expansion chassis is not supported.
CAUTION: Ensure that the cabinet weight (populated with chassis, drives, units) does not exceed
the floor loading specifications.
You should record the total weight of your applicable cabinets (with contents). Use this information
to check floor loading restrictions and/or elevator weight restrictions.
Figure 9 provides a standard cabinet fully populated with storage and servers (front of cabinet, with
door closed).
Figure 9 Fully Populated Cabinet
QXS System and Cabinet Information9
10QXS 12G Site Planning Guide
Loading...
+ 40 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.