Quantum QP-650 User Manual

QP-650
user manual
Quantun Electronics,LLC
Government law prohibits the operation of unlicensed radio transmitters. Illegal operation is punishable by fine or imprisonment
Of both. To avoid problem caused by electromagnetic interference and
electromagnetic compatibility, please turn off the transceiver at the sites where you are required, such as hospital, airplane etc.
In the vehicle equipped with air bag safety, don't put the transceiver within the scope of the air bag inflation.
Please turn off the transceiver before step into the inflammable and explosive places.
Don't transmit for a long time, it may damage the transceiver or it may cause scald.
Don't use the transceiver which antenna is damaged or else when
the exposed metal touch the skin, it may cause scald also.
Don't expose the transceiver to long periods of direct sunlight, nor place it close to heating appliances.
If belt the transceiver on with belt clip, please notice that the distance Between body and antenna should be more than 5cm when transmitting. If an abnormal odor or smoke is detected coming from the transceiver, switch OFF the power immediately and remove the optional battery pack from the transceiver. Contact our dealer nearby.
NOTICES TO THE USER
We are grateful for you choice of Quantun transceiver.
This Professional two-way radio incorporates the
advanced technology and craft. You will be pleased
with the quality and features of our product. Please
read this manual carefully to ensure you know how
to property operate the radio before use.
THANK YOU
3
User Safety, Training, and General Information
READ THIS IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION BEFORE USING YOUR QUANTUN PORTABLE TWO-WAY RADIO.
Compliance with RF Energy Exposure Standards
Your Quantun two-way radio is designed and tested to comply with a number of national and international standards and guidelines (listed below) regarding human exposure to radio frequency electromagnetic energy. This radio complies with the IEEE (FCC) and ICNIRP exposure limits for occupational/controlled RF exposure environment at duty cycles of up to 50% talk-50% listen and should be used for occupational use only. In terms of measuring RF energy for compliance with the FCC exposure guidelines, your radio radiates measurable RF energy only while it is transmitting (during talking), not when it is receiving (listening) or in standby mode. Note: The approved batteries supplied with this radio are rated for a 5-5-90 duty cycle (5% talk-5% listen-90% standby), even though this radio complies with the FCC occupational RF exposure limits at duty cycles of up to 50% talk.
Your Quantun two-way radio complies with the following of RF e ne rg y exposure standards and guidelines:
z United States Federal Communications Commission, Code of Federal Regulations;
47CFR part 2 sub-part J
z American National Standards Institute (ANSI)/Institute of Electrical and Electronic
Engineers (IEEE) C95. 1-1992
z Institute of Electrical and Electronic Engineers (IEEE) C95. 1-1999 Edition z International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998 z Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to Radio
Frequency Electromagnetic Fields in the Frequency Range from 3KHz to 300GHz, 1999
4
Operational Instructions and Training Guidelines
To ensure optimal performance and compliance with the occupational/controlled environment RF energy exposure limits in the above standards and guidelines, users should transmit no more than 50% of the time and always adhere to the following procedures:
Transmit and Receive
To transmit (talk), push the Push-To-Talk (PTT) button; to receive, release the PTT button.
Hand-held radio operation
Hold the radio in a vertical position with the microphone one to two inches (2.5 to 5 cm) away from the lips.
Body-worn operation
z Always place the radio in a Quantun approved clip, holder, holster, case, or body
harness for this product. Use of non-Quantun-approved accessories may exceed FCC RF exposure guidelines.
z If you do not use a Quantun approved body-worn accessory and are not using the
radio in the intended use position in front of the face, then ensure the antenna and the radio are kept one inch (2.5 cm) from the body when transmitting.
Antennas & Batteries
z Use only Quantun approved, supplied antenna or Quantun approved replacement
antenna. Unauthorized antennas, modifications, or attachments could damage the radio and may violate FCC regulations.
z Use only Quantun approved, supplied batteries or Quantun approved replacement
batteries. Use of non-Quantun-approved batteries may exceed FCC RF exposure guidelines.
Approved Accessories
For a list of Quantun approved accessories, see the accessories page of this user manual or visit the following website which lists approved accessories: http://www.Quantun.com
5
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
z Reorient or relocate the receiving antenna. z Increase the separation between the equipment and receiver. z Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
z Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Compliance
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numerique de la classe B est conforme à la norme NMB-003 Canada.
FCC Requirements
Your radio must be properly licensed by the Federal Communications Commission prior to use. Your Quantun Wireless dealer can assist you in meeting these requirements. Your dealer will program each radio with your authorized frequencies, signaling codes, etc., and will be there to meet your communications needs as your system expands.
Caution:  Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.  Operation is subject to the condition that this device does not cause harmful interference
Loading...
+ 10 hidden pages