Quantum EMPIRE 540 DATASHEET

Empire 540
SCSI Jumper Settings
Jumper Settings
Termination Enable (TE)
Enable termination Disable termination
Termination Power (TP / J13)
Enable termination power Disable termination power
SCSI ID (A2, A1, A0)
Set drive SCSI ID
Wait Spin (WS)
Enable wait spin Disable wait spin
TE jumper on TE jumper off
TP jumper on TP jumper off
See ID settings table below
WS jumper off WS jumper on
1 of 1
Empire 540
SCSI Jumper Settings
Write Protect (WP)
Enable write protect Disable write protect
Jumper Locations
The Empire disk drive has one location where user configurable jumpers are found. The primary jumper block location for the Empire drive is found on the printed circuit board, near the SCSI cable connector.
SCSI ID Settings
The following table identifies the various SCSI ID values and the jumper positions required to set them.
Drive ID
ID 0 ID 1 ID 2 ID 3 ID 4 ID 5 ID 6 ID 7
A0
OFF
ON
OFF
ON
OFF
ON
OFF
ON
WP jumper on WP jumper off
A1
OFF OFF
ON
ON OFF OFF
ON
ON
A2
OFF OFF OFF OFF
ON ON ON ON
2 of 2
Loading...
+ 2 hidden pages