Quanta Microsystems ZM101 User Manual
Quanta Microsystems Inc.
ZM101 module operation manual-RF mode
Quanta Microsystems, Inc.
Subject:
Doc No.
ZM10 operation manual-RF mode
OP_ZM10X-1
Revised Date:
2008/03/28 Page: 2 of 10
Reason for Release：
Revision Effective Date Author Description of Changes
0.1 03/28/2008 Samuel Wang Modified from OP_ZM100-1
Rev: 0.2
QMI PROPERTY & CONFIDENTIAL!
2
Quanta Microsystems, Inc.
Subject:
Doc No.
1. Adaptor board connection and setup
ZM101 operation manual-RF mode
OP_ZM10X-1
Power IN (+2.7~+3.3Vdc)
USB plug in:
― J_USB should be selected as USB PWR IN mode
― USB +5V Æ LDOÆPower in
RCA Jack plug in:
― J_DC should be 2-3 pin short.
― Use a +4~7V(inner) DC adaptor plug in CON_RCAÆ LDOÆPower in
Pin header plug in:
― Use other power source(such as power supply)
― Supply +2.7~+3.3V and plug in by J_3V pin headerÆPower in
Revised Date:
Rev: 0.2
2008/03/28 Page: 3 of 10
Fig1.1 Adaptor board and DUT test setup
QMI PROPERTY & CONFIDENTIAL!
3
Quanta Microsystems, Inc.
Subject:
Doc No.
ZM10 operation manual-RF mode
OP_ZM10X-1
Revised Date:
Adaptor board placement and jumper selection
Rev: 0.2
2008/03/28 Page: 4 of 10
J_CURRENT: For DC current measurement use; Default is short by Jumper.
J_DC: DC input selection
― 1-2 Short by Jumper : Use USB +5VÆLDOÆ3.3V
― 2-3 Short by Jumper : Use RCA Jack
― Open : Use J_3V pin header
CN USB: Insert USB A-type cable connect to USB host to provide +5Vdc.
CN_RCA : Provide +4~7Vdc by RCA Jack.
J_3V : Provide +2.7~3.3V by pin header, positive port are marked in square.
CN9 : D-SUB9 for UART console.
CON4 : insert 4-wire cable connect to DUT for FW download.
CON6 : insert 6-wire cable connect to DUT for RF testing.
QMI PROPERTY & CONFIDENTIAL!
4
Loading...