Quanta Computer MSBUQCI User Manual

WMA1

PCMCIA Type II Wireless LAN Card

User Manual

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, (example - use only shielded interface cables
when connecting to computer or peripheral devices) any changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

Statement Needed to be Shown on End Product

Since this module is installed inside the end product, the end product should be affixed a label
on visible area showing that this product contain a RF module, and also its FCC ID.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.

Manufacturer's Disclaimer Statement

The information in this document is subject to change without notice and does not represent a
commitment on the part of the vendor. No warranty or representation, either expressed or
implied, is m ade with respect to th e quality, accur acy or fitness for any particular purpose of
this document.
The manufacturer r eserves the right to make c hanges to the conte nt of this docum ent and/or
the products associated with it at any time without obligation to notify any person or
organization of such changes . In no event will the manufac turer be liable for direct, indirect,
special, incidental or consequential damages arising out of the use or inability to use this
product or documentation, ev en if advised of the possibilit y of such damages . This docum ent
contains materials prot ected by cop yright. All rights are res erved. No part of this m anual m ay
be reproduced or transmitted in any form, by any means or for any purpose without expressed
written consent of its authors. Product nam es appearing in this document are mentioned for
identification purchases only. All trademarks, product names or brand names appearing in this
document are registered property of their respective owners.

Printed in Taiwan

1. INTRODUCTION........................................................................................................................ 5

1.1 Overview

1.2 Features

2. DEVICE DESCRIPTION............................................................................................................ 5

2.1 Appearance before installed on the Master Board

2.2 Appearance after installed on the Master Board

3. INSTALLATION THE CARD ................................................................................................... 6

4. APPLICATION............................................................................................................................ 9

5. HARDWARE TECHNICAL SPECIFICATION OF WIRELESS LAN............................... 10

STANDARD COMPLIANCE

.........................................................................................5

..........................................................................................5

...................................5

......................................6

........................................................................................................ 10