Quality Craft QCC-1000, QCC-2000, QCC-1500 Instruction Manual

CONVECTION HEATER

I N S T R U C T I O N M A N U A L

MODELS QCC-1000 / QCC-1500 / QCC-2000

Warning: Read all instructions before
using this convection heater.

Warning: In Quebec, the installation of
this product must be carried out by a
qualified electrician.

2

IMPORTANT SAFETY INSTRUCTIONS

WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAU­TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS, IN­CLUDING THE FOLLOWING:

S A F E T Y I N S T R U C T I O N S

1. Read all instructions carefully
before using the heater.

2. This heater is hot when in use. To
avoid burns, do not let bare skin
touch hot surfaces. If provided,
use handles when moving this
heater. Keep combustible mate­rials such as furniture, pillows,
bedding, papers, clothing and
curtains at least 3 feet (0.9 m)
away from front, sides and rear
of the heater.

3. Extreme caution is necessary
when any heater is used by or
near children or individuals with
disabilities and whenever the
heater is left operating and unat­tended.

4. Always unplug the heater when
not in use.

5. Do not operate any heater with a
damaged cord or plug or after the
heater manlfunctions, has been
dropped or damaged in any

manner. Return heater to an

authorised service facility for
examination, electrical or
mechanical adjustment
or repair.

6. Do not use outdoors.

7. This heater is not intended for use
in bathrooms, laundry areas or
in wet or moist indoor locations.
Never place the heater where it
may fall into a bathtub or other
water containers.

8. Do not run the electric cord under
carpeting. Do not cover the cord
with throw rugs, runners, or
similar coverings. Do not place
the cord in a traffic area.

9. To disconnect the heater, turn
controls to “off”.

10. Do not insert or allow foreign
objects to enter any ventilation
or exhaust openings. Do not use
on soft surfaces, such as a bed
where openings may become
blocked.

11. A heater has hot and arcing or
sparking parts inside. Do not use
it in areas where gasoline, paint,
or flammable liquids are used
or stored.

Warning: In Quebec, the installation of this product must be
carried out by a qualified electrician.

3

12. Use this heater only as described
in this manual. Any other use
not recommended by the manu­facturer may cause fire, electric
shock, or injury to persons.

13. Avoid the use of an extension
cord.

SAVE THESE INSTRUCTIONS
FOR FUTURE USE.

General Information

This convection heater is intended
for permanent wall-mounting with
the provided brackets, which must
be operated with a line voltage ther­mostat. (The line voltage thermostat
is not provided with the heater.)

The heater has a thermal cut-off pro­tection. If the thermal cut-off protec­tion trips, switch off the power. The
unit should reset automatically after
10 minutes. If the thermal cut-off
protection trips again, determine the
reason for overheating.

Specifications

Model QCC-1000W
Volts 240

(CD1)

V AC
Watts 1000 W
Height 443 mm (17.4 in)
Width 581 mm (22.9 in)
Depth 102 mm (4.0 in)

S A F E T Y I N S T R U C T I O N S / I N S TA L L AT I O N

Model QCC-1500W
Volts 240

(CD1)

V AC
Watts 1500 W
Height 443 mm (17.4 in)
Width 726 mm (28.6 in)
Depth 102 mm (4.0 in)

Model QCC-2000W
Volts 240

(CD1)

V AC
Watts 2000 W
Height 443 mm (17.4 in)
Width 889 mm (35 in)
Depth 102 mm (4.0 in)

Installation

Tools required:

- Electric drill

- Phillips (cross-head) screwdriver

- Tape measure

Do not install heater closer than 152
mm (6 in) to a vertical or horizontal
surface. This minimum distance
must be maintained.

INCM

IN

CM

INCM

4

I N S TA L L ATI ON / M A I N T E NA NC E / C L E AN IN G

Wall Mounting

1) Drill the required holes in the
wall using the positioning screw
holes.

2) Attach the bracket to the wall with
the screws.

3) Mount the heater to the bracket
and engage the corresponding
slots on the rear of the heater.

Removing the heater
from the bracket

1) Press and loosen all clips.

2) Pull the heater to disengage
the clips from the bracket.

Electrical Wiring

Warning: The heater must be
installed by a certified electrician
and in accordance with the local and
national building codes.

Warning: In Quebec, the installation
of this product must be carried out
by a qualified electrician.

Warning: This convection heater
is to be used on a 240/208

(CD1)

V AC

power supply and grounded outlets.

Maintenance

Warning: To reduce the risk of fire
or electric shock, always switch off
the unit and wait 10 minutes to
allow it to cool before attempting
any maintenance or cleaning. It is
recommended that the heater is
cleaned periodically, in order to avoid
dust blocking the grill or ventilation.

Cleaning

Wipe the unit with a soft, damp cloth.
Do not use abrasive cleaners or
spray liquids on the unit surfaces.

Note: It is possible that the unit
surface may discolour (yellow) over
time, due to dust or cigarette smoke.
This is normal and not a manufac­turing defect.

"LACK,

4HERMALCUTOFF

PROTECTION

7HITE.

'REEN9ELLOW'