Qualitel C33R User Manual

C33R Repeater

User manual

Getting to know your Repeater

LED INDICATOR STATUS:
Off = Power supply is off Blue (Double flash) = Repeater in use with good signal

Red/Blue = In registration mode Purple (Steady) = Weak link to telephone base station
Blue (Triple flash) = Registration com plet ed suc cessf ully Purple (Double flash) = Repeater in use with weak link

to base station

Blue (Steady) = Good link to telephone ba se stati on Red (Steady) = No link to telephone base station

Setting up

Connect the mains pow er adaptor

Plug the small end of the power adaptor cable into the socket on the back of the Repeater.

Then plug the other end into the mains wall socket but don’t switch the power on at the wall socket yet.

Use a power socket close to your telephone base station. This is because during the registration process, the telephone base
station needs to be near the Repeater. You can relocate your Repeater after registration is complete.

Warning

Only use the power adaptor supplied otherwise your product may not work and you could damage the product.

Automatic registration to the telephone base station

1. Before beginning registration, make sure that all unregistered Repeaters are switched off.

2. Turn on the Repeater mode in the telephone base station that you will be registering the Repeater to. This varies dependant on
the product, the instruction can be found in the User guide, provided with the telephone base station.

3. Put the telephone base station into registration mode, this is normally done by pressing and holding the Find button, but again
consult the User guide, provided with the base station.

4. Switch on the power t o the R epeater at the wall socket and the Repeater w ill register automatically . The LED on the Repeater will
toggle between Red and Blue, followed by a triple blue flash to confirm that registration is complete. The LED will remain blue to
indicate that the registration is complete.

5. You can now safely disconnect the power and move the Repeater to your selected location. The Repeater will remain registered
to the telephone base station.

NOTE: If the LED continues to flash red, try registering the Repeater again.