Qualcraft Side Wall Staging Bracket User Manual
SIDE WALL STAGING BRACKET
MODEL #2300, #2301
CONSTRUCTION
PRODUCTS
Side Wall
Staging Bracket
Model # 2300
This sturdy, steel con struct ed
brack et bolts through walls with
ad just ment for wall thickness.
Supports a 36” plat form con struct ed of 2” thick planks. Holds
two work ers plus 75lbs. per 8
foot stag ing, no more than 8 foot
span be tween brack ets. Must use
guardrails when in stalled over 6
feet above ground. Folds for compact storage and trans por ta tion.
Staging Bracket Guard Rail
Model # 2301
You must use guardrails when
in stalling staging over 6 feet above
ground.
Product Speci cations
Model # 2300 2301
Description: Staging Bracket Staging Bracket/Guardrail
Unit Pack: 1 1
Weight per Pack: 10.5 Pounds 7 Pounds
Cu. Ft. per Pack: .31 cu. ft. .31 cu. ft.
Customer Supprt and Ordering In for ma tion
781-344-1000 • www.qualcraft.com
CONSTRUCTION
PRODUCTS
SIDE WALL STAGING BRACKET
MODEL #2300, #2301
INSTRUCTIONS FOR INSTALLATION
AND USE OF STAGING BRACKET
MODEL #2300
CAPACITY: Capacity of the Model #2300
Staging Bracket is two men per staging plus
75 lbs.
GENERAL REQUIREMENTS: The brackets
may be spaced no more than 8 ft. apart. The
platform shall consist of not less than 2 inch
x 10-inch planks extending not more than
10 inches or less than 6 inches beyond each
staging bracket. The platform of each staging
bracket must be fully planked. Do not nail stag-
ing brackets onto the wall for support. Guardrails
and toe boards must be used on all staging 6 ft. or more above the ground.
Always use a Qual-Craft Model #2301 Guardrail Holder with the installation
of each staging bracket.
INSTALLATION INSTRUCTIONS: WARNING: Do not install staging bracket
scaffolding directly onto walls constructed of sheathing materials other than
inch thick exterior grade plywood. To install rst bracket choose a location
between two interior studs that is no more than 2 inches from one of the studs
and drill a 5/8 inch clearance hole. Prepare a 2”x 4” plank (clear - no knots or
cracks) long enough to span the interior studs and drill a 5/8” clearance hole
in the center of the 4” face in a location corresponding to the exterior hole
previously drilled. Place the staging bracket against the work wall so that the
bolt protrudes through both the surface hole and the corresponding hole of
Customer Supprt and Ordering Information
781-344-1000 • www.qualcraft.com
Loading...