Qualcraft PRO-LINE Adjustable Roof Bracket User Manual

STEEL • ADJUSTABLE ROOFING BRACKETS

Model #3500

Model #2500

ROOFING

PRODUCTS

Adjustable Steel Roof Brackets

Heavy Duty Model #2500 PRO-line Model #3500

Durable heavy duty steel construction. Designed to hold a 10” platform. Easy installation and removal without damaging shingles. Adjustable three or four position platform, dependent on model line. Additional safety features include a platform retainer and unique locking mechanism Capacity: 1 worker per 8’ staging plus 40 lbs. Maximum 8’ spacing between brackets.

Easy to set up, operate, reposition and take down without damage to shingles. Folds at for compact storage.

For use on VARIABLE PITCH ROOFS AND PROJECTS

HEAVY DUTY - Model #2500 10" x [ 30º, 45º, or 60º ]

PRO-LINE - Model #3500 10" x [ 30º, 45º, 60º, or 90º ]

Product Specications

Model # 2500 3500 Description: 10” Adjustable 10” Adjustable Welded w/Gusset Unit Pack: 10 / Carton 12 / Carton Weight per Pack: 24 Pounds / Carton 45 Pounds Cu. Ft. per Pack: .52 cu. ft. 1.28 cu. ft.

Model #2500

Model #3500

Customer Support and Ordering Information

PO Box 559 • Stoughton, MA 02072

781-344-1000 • www.qualcraft.com

ROOFING PRODUCTS

Model #2500

STEEL • ADJUSTABLE ROOFING BRACKETS

Model #2500

INSTRUCTIONS FOR INSTALLATION AND USE OF THE MODEL #2500 & #3500 10” ADJUSTABLE ROOFING BRACKET: CAPACITY: One worker per 8 feet of scaffolding plus 40 pounds of materials.

GENERAL REQUIREMENTS: When installed, the platform support arm must be set to match the pitch of the roof, allowing for the installation of a fully decked and level walk surface. MOUNTING THE ROOF BRACKET: 1) All brackets shall be attached to the roof with 20-penny nails. Use all teardrop holes on left or all slots on right side of mounting plate as desired. 2) Position bracket so that all nails penetrate both the roof’s surface and the rafter below. 3) Spacing between brackets shall not exceed 8 feet. INSTALLING PLATFORM: 1) wood platforms shall not be less than 2 inches nominal thickness and shall extend beyond the support arm not less than 6 inches and not more than 12 inches.

2) Always use clear, straight-grained wood free from knots or defects. 3) If extended length platforms are required, use additional Roof Brackets every 8 feet. 4) Secure to bracket by nailing the platform to the bracket using the hole provided in the platform retainer. INSTRUCTIONS FOR USE: 1) No more than one person shall occupy any given 8 feet of a Roong Bracket Scaffold. 2) Always use OSHA compliant fall arrest system, guardrails, catch platforms or other safety equipment as required by Local, State or Federal OSHA Regulations. 3) Roof Brackets are intended for use by the experienced tradesman. 4) OSHA Regulations require that employers provide training in the use and care of this product. CARE AND MAINTENANCE: 1) Inspect all Roong Brackets before each use to be sure that there is no damage or deformation, or deterioration from rusting. Discard if necessary. 2) Do not throw or drop from a building or onto a truck. 3) Do not use if exposed to extreme heat or cold. Discard at once. 4) Do not use if wet or frozen.

PO Box 559 • Stoughton, MA 02072

Customer Support and Ordering Information

781-344-1000 • www.qualcraft.com