Bunk Jack
Part #: 10573
Instructions
Compliant with all applicable OSHA 1910 and 1926 regulations.
Custom configurations not available. Not repairable.
Contact customer service for details.
(2) Bunk Jacks required to receive up to 66 sheets of
½” CDX plywood. (1) HitchClip™ required per (1) Bunk Jack.
Bunk Jacks are specially designed to be utilized during
construction to accommodate a full bunk of plywood, or
to create a rooftop workstation, and can be adjusted to fit
a 6/12-12/12 pitch..
Maximum weight per pair of Bunk Jacks: 4,000 lbs.
(including all workers, tools, and equipment).
Plywood
Location
Headpin
Locking Pin
Installation and Use:
1. Install all necessary HitchClips™ according to manufacturer’s
instructions. When used with Bunk Jacks, recommended spacing
between HitchClips™ is 6’.
2. Insert Bunk Jack Headpin into HitchClip™ key hole attachment
point from top to bottom, and ensure Bunk Jack fully locks into
place. HitchClip™ and Bunk Jack must be perpendicular to leading
edge of fall hazard.
3. Adjust Bunk Jack so that platform staging will lie flat when
installed. Secure and lock Bunk Jack with provided Locking Pin.
4. Place plywood across Bunk Jacks.
Materials: aluminum.
UPC-A Code: 672421105734
Qualcraft Industries 60 Maple St., P.O. Box 36, Mansfield, MA 02048 phone: (800) 231-5647 www.qualcraft.com