Qtx QTFX-2000 mkII User Manual

QTFX-2000 mkII

HIGH POWER FOG MACHINE

Item ref: 160.473UK

User Manual

160.473UK User Manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Introduction

Thank you for choosing the QTFX-2000 mkII fog machine for stage and events special effects. This product is
designed to produce high power fog effects for stage and theatre shows. Please read these instructions fully in
order to gain the best results from this item and avoid damage to the unit through misuse.

Unpacking

Your QTFX-2000 mkII should reach you in good condition and should be supplied with IEC mains lead(s),
wired remote timer control, wireless plug-in receiver and key fob remote.
If there are any signs of damage or items missing from the packaging, contact your dealer immediately.

Warning

To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on areas other than inside the fluid tank, disconnect the mains, allow the QTFX-2000 mkII
to dry out and have it checked by qualified service personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case.
Allow the QTFX-2000 mkII to acclimatize to room temperature before operating.
Refer all servicing to qualified service personnel.

Safety Symbol and Message Conventions



CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

AVIS

RISQUE DE CHOC ELECTRIQUE

NE PAS OUVRIR

This symbol indicates that dangerous voltage constituting a risk of electric shock is present

within this unit

This symbol indicates that there are important operating and maintenance instructions in the

literature accompanying this unit.

Safety

 Check for correct mains voltage and condition of the IEC lead before connecting to a power outlet
 Check the condition of the remote lead and ensure that it is not trapped
 This unit uses a heating element – be aware that parts of the housing may be hot whilst in use!

This unit must be earthed

Cleaning

 Use a soft dry or slightly damp to clean the casing
 Do not use strong solvents for cleaning the unit
 Clean the fog mechanism periodically by operating with distilled water instead of fog fluid
 It is also recommended to use fog machine cleaning fluid (160.670UK) periodically