QSC Audio ALK-MD2, ALK-MD3 User Manual

The ALK-MD2 and ALK-MD3 Array Link Kits
allow the user to quickly, easily and cost
effectively assemble arrays of ModularDesign
loudspeaker systems. The ALK-MD2 allows
the construction of arrays that are two
enclosures wide (Figure A) while the
ALK-MD3 can be used to assemble three­wide arrays (Figure B). Arrays can be
constructed using any trapezoidal enclosure
full range or low-frequency model of the
MD or MD Powered product range.

Arrays of up to six enclosures may be
constructed by using multiple Array Link
Kits to add a second “row” of two or three
enclosures suspended below and from the
first (Figure C).

Array Link Kits

ModularDesign Series Accessories

ALK-MD2 | ALK-MD3

75º Splay 45º Splay

Figure A − 2-wide Arrays

Splay angles between adjacent enclosures
can be adjusted in five degree increments
from 45º to 75º. (Included angle between
aiming axes) The design of the ALK-MD3
allows the splay angle between the center
enclosure and those on the left and right to
be adjusted independently.

Array Link Kits consist of a number of steel
plates, four in the case of the ALK-MD2 and
six for the ALK-MD3. These plates attach
to the top and bottom of MD enclosures,
making use of the existing suspension
attachment points. Each plate has multiple
mounting holes, all clearly labeled, that
are used to set the splay angle between
enclosures. Each kit includes all hardware
required to assemble an array as well as
three forged shoulder eyebolts to facilitate
suspension of the assembled array.

75º Splay (x2) 45º Splay (x2)

Figure B − 3-wide Arrays

Figure C − 2-row Arrays

1675 MacArthur Boulevard • Costa Mesa, CA 92626 • Ph: 800/854-4079 or 714/957-7100 • Fax: [phone]

Array Link Kits 04/12/07

qscaudio.com