Qomo QIT 300, QIT 500 User Manual

QIT

300 & 500

User Manual

Table of Contents

Chapter 1. What is in the box...........................................................2

Chapter 2. System Requirements....................................................4

Chapter 3. Product Introduction......................................................4

Chapter 4. Setup................................................................................5

Chapter 5. Electromagnetic Pen......................................................6

Chapter 6. Features...........................................................................7

Chapter 7. Software Operation Basics............................................8

Chapter 1. What is in the box

Electromagnetic LCD Writing Panel (1)

USB Cable (1)

VGA Cable (QIT300) or Built -in (QIT500)

2

Power Cord (QIT300) or Power Brick (QIT500)

AAA Battery for Pen (1)

Electromagnetic Pen (1)

Pen Holder (QIT500)

Installation CD (1)

Owner’s Manual (1)

If any items are missing or damaged, contact the dealer where you purchased

the panel immediately.

Chapter 2. System Requirements

Please check the contents of the box to make sure that the following parts are

included.

Software:

Installation CD-ROM, it contains application Software setup and driver setup.

Hardware:

Electromagnetic LCD Writing Panel (1)

Electromagnetic Pen (1)

Power Cord (1)

VGA Cable (1)

USB Cable (1)

Additional Hardware:

If the user uses a single VGA output display card and wants to connect the LCD

Writing Panel system to an external projection device, the following additional

components are required.

VGA Distribution Amplifier (1) (not supplied by QIT-500)

Additional VGA cables (2) (not supplied by QIT-500)

System Requirements:

3