Qomo QD8000 User Manual

PRECAUTIONS

Please follow these precautions:

To prevent fire or shock hazard, do not expose the unit to rain or moisture.
To prevent electrical shock, do not open the cabinet. Refer to qualified

personnel for service only.
Do not use the unit continuously for more than 24 hours with camera auto
focus on. It may cause damage to the camera lens.
Be careful not to spill water or other liquids onto the unit, or allow

combustible
or metallic objects to get inside the cabinet.
Unplug the visualizer from the wall outlet when it is not in use for
an extended period of time.

Clean cabinet with a soft cloth lightly moistened with a mild detergent.
Clean lens carefully with an air spray or soft dry cloth to avoid scratching.
When lamps flash or become dark, they should be replaced with new ones.
Avoid interchanging arm lights and back light frequently.

CONTENTS:

The table of contents is empty because none of the paragraph styles selected in the
Document Inspector are used in the document.

1

PARTS IDENTIFICATION

1: LCD Monitor

2: Stage

3: Operation Panel

4: Camera Stand I

5: Camera Stand II

6 : C a m e r a C o v e r
Switch

7: Camera Stand
Button

8: Remote Control
Receiver

9: Camera Head

10: Camera Cover

11: Arm Light

12: Arm Light Stand

CONTROL PANEL

ROTATE (Rotate the image)

2

Neg (Display film negatives)
SPLIT (Image Split function)
FREEZE (Freeze the image)
TEXT (Switch between image/text mode)
FAR/NEAR (Focus far or near)
TELE/

IDE (Zoom in and out)
BRIGHT+/- (Increase or decrease the brightness)
CAM/PC1/PC2 (Camera/RGB input signal selection)
S-VIDEO/VIDEO (S-Video/ Video input signal selection)
LAMP (Control the arm lights and back light)
AUTO (To auto adjust brightness, auto white balance and auto focus)
POWER (Control the visualizer On/Off)(When indicator is flashing, it can

unlock the operation panel)

REMOTE CONTROL

Remarks: the following buttons are not available: SCREEN / , SET,
RUN, MIRROR, NUBERICAL KEY, 2 DIV.
POWER (Control the visualizer On/Off)
ROTATE (Rotate the image)
FREEZE (Freeze the image)
LAMP (Control the arm lights and back light)
SAVE (Save captured images)
NEGA (Display film negatives)

3

XGA (Switch between SXGA mode and XGA mode)
DIV. (Multiple Screen Display)
TEXT (Switch between image/text mode)
B&W (Switch between Color mode and Black & White mode)
PROJECTOR POWER (Control the projector On/Standby)
PROJECTOR INPUT (Projector input signal selection)
EXIT (Exit selected function)
TELE/

IDE (Increase and decrease magnification)
FAR/NEAR (Focus far or near)
AUTO (To auto adjust brightness, auto white balance and auto focus)
PC INPUT (Camera/RGB input signal selection)
AV INPUT (VIDEO input signal selection)
VOLUME+/- (Increase or decrease the volume)
BRIGHT+/- (Increase or decrease the brightness)

SCROLL

/ (Move the image up/down)

BASIC PREPARATIONS

Hold and pull the camera stand I up to setup camera stand I.

Rotate the camera stand back forwards to make camera stand II out
automatically.

4

Setup arm light to proper position.

Setup camera head to proper position

5

Press down camera cover button to open camera cover.

3. Making connections:

Before making any connections, turn off all the power. Please ensure that

the visualiVer along with all other equipment to be connected are turned off.

Step 1: Connect power source.
First connect the power cord to the 12V IN connector.

Step 2: Connect to the projector.

6