QOLSYS IQ MINI DW S Series, IQ MINI DW, IQ Mini Dw Extended S Line Quick Install Manual

STEP

1

IQ MINI DW S-LINE QUICK INSTALL GUIDE

✓

Exterior Doors

✓

Sliding
glass
doors

Windows

✓

CHOOSE
INSTALLATION

LOCATION

Also great for:

Medicine cabinets
Gun safes

Garage doors
Interior doors

SPECIFICATIONS

SEE REVERSE FOR REMAINING STEPS

Sensor: 2.25”H x 1”W x .5”D

Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm, alarm
restore, low battery.
Transmitter frequency: SECURE 319.5 MHz (S-Line)
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m

Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C

Replace battery with exact replacement every 5 years
with 3V Lithium (x2).

(2) -Panasonic CR2032

-Energizer CR2032

-Duracell DL2032

This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

STEP

2

STEP

4

STEP

5

SECURE
SENSOR &
MAGNET

STEP

6

Document#: IQS-MDW-SQG-02-17
Revision#: 2/24/17
Issue Date: FEB 2017
Qolsys Product #: QS1115-840

APPLY
ADHESIVE

REMOVE
BATTERY

TABS

3/4”

Apply provided
adhesive strips to
the back of
sensor and
magnet.

Magnet gap
should not
exceed 3/4”

STEP

3

LEARN
INTO

PANEL

Place your panel in

“autolearn" mode

Customize name and settings

as desired and and touch “ADD”

ADD

Open and close the case

to “tamper” the device

Magnet locator mark
Magnet

Sensor

LINE UP
SENSOR &
MAGNET

[e-mail]

CONTACT TECH SUPPORT

GOT QUESTIONS?

Qolsys Inc. proprietary.

Reproduction without permission is not permitted.

FCC ID: 2ABBZ-RF-MDWS

IC: 11817A-RFMDWS

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute

interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.