How it Works
QNAP
Loading...
TVS-951X-2G
User manual
43 pgs1.59 Mb0
User manual [de]
44 pgs1.6 Mb0
Technical data
2 pgs18.88 Kb0
Table of contents
Loading...

QNAP TVS-951X-2G User manual

TVS-951X
User Guide
Document Version: 1 21/05/2018
TVS-951X User Guide

Contents

1. Preface
About This Guide.......................................................................................................................................... 3
Audience.......................................................................................................................................................3
Document Conventions................................................................................................................................ 3
2. Product Overview
Front Panel...............................................................................................................................................7
Rear Panel................................................................................................................................................7
Front Drive Numbering............................................................................................................................. 8
3. Installation and Configuration
Hardware Installation.................................................................................................................................. 10
Drive Installation.....................................................................................................................................10
Replacing Memory Modules...................................................................................................................17
QTS Installation.......................................................................................................................................... 22
Installing QTS Using Qfinder Pro........................................................................................................... 22
Installing QTS Using the Cloud Key....................................................................................................... 24
Installing QTS Using an HDMI Connection............................................................................................ 25
4. Basic Operations
Power Button.............................................................................................................................................. 27
Reset Button............................................................................................................................................... 27
USB One Touch Copy Button..................................................................................................................... 27
LEDs........................................................................................................................................................... 28
Beep Alarm................................................................................................................................................. 29
5. Troubleshooting
6. Glossary
7. Notices
Limited Warranty.........................................................................................................................................33
Disclaimer................................................................................................................................................... 33
GNU Public License....................................................................................................................................33
1
FCC Notice................................................................................................................................................. 41
CE Notice....................................................................................................................................................41
SJ/T 11364-2006.........................................................................................................................................42
2
TVS-951X User Guide

1. Preface

About This Guide

This guide provides information on the QNAP TVS-951X NAS and step-by-step instructions on installing the hardware. It also provides instructions on basic operations and troubleshooting information.

Audience

This document is intended for consumers and storage administrators. This guide assumes that the user has a basic understanding of storage and backup concepts.

Document Conventions

Symbol Description
Notes provide default configuration settings and other supplementary information.
Important notes provide information on required configuration settings and other critical information.
Tips provide recommendations or alternative methods of performing a task or configuring settings.
Warnings provide information, that when ignored, may result to potential loss, injury, or even death.
Preface 3
TVS-951X User Guide

2. Product Overview

This chapter provides basic information about the QNAP TVS-951X NAS.

About the TVS-951X

With a reliable dual-core processor, an HDMI port, and 1GbE and 10GBASE-T ports, the TVS-951X balances its compact size with a powerful feature set adaptable to a range of situations. Accommodating up to nine storage drives, the TVS-951X meets the storage, backup, restoration, and private cloud needs of most small to medium-sized businesses. The TVS-951X also features a hardware-accelerated encryption engine which keeps data secure.

Hardware Specifications

Important
Modifying the hardware or software of your QNAP product invalidates the warranty. QNAP is not responsible for any damage or data loss caused by unauthorized modifications and installation of unsupported third-party applications.
Component TVS-951X
Ordering Information
Ordering P/N • TVS-951X-2G
• TVS-951X-8G
Processor
CPU Intel® Celeron® 3865U dual-core 1.8 GHz processor
Architecture 64-bit
Encryption engine AES-NI
Memory
Pre-installed memory • 2 GB RAM: 1 x 2 GB DDR4
• 8 GB RAM: 2 x 4 GB DDR4
Important
• Use only QNAP memory modules to maintain system performance and stability. For NAS devices with more than one memory slot, use QNAP modules with identical specifications.
• Using unsupported modules may degrade performance, cause errors, or prevent the operating system from starting.
Total memory slots 2 x SODIMM DDR4
Maximum memory 32 GB (2 x 16 GB)
Flash Memory 512 MB
Storage
Drive bays • 5 x 3.5-inch SATA 6 Gbps bays
• 4 x 2.5-inch SATA 6 Gbps bays
Product Overview 4
Component TVS-951X
Drive compatibility • 3.5-inch bays:
• 3.5-inch SATA hard disk drives
• 2.5-inch SATA hard disk drives
• 2.5-inch SATA solid state drives
• 2.5-inch bays:
• 2.5-inch SATA solid state drives
Hot-swappable Yes
Network
10 gigabit Ethernet ports 1 x RJ45
Note
• This port supports 10GbE, 5GbE, 2.5GbE, 1GbE and 100Mbps networking speeds.
TVS-951X User Guide
• A CAT6a or CAT7 cable is required to achieve 10GbE speeds (not included).
Gigabit Ethernet ports 1 x RJ45
External I/O Ports & Expansion Slots
USB ports • Front: 1 x USB 3.0 Type-A
Note
You can use the One-Touch Copy button with this port.
• Rear: 3 x USB 3.0 Type-A
HDMI outputs 1 x HDMI v1.4b, up to 4096 x 2304 resolution at 24Hz
Audio • 1 x 3.5 mm line-out jack
• 1 x speaker
Note
You cannot use the speaker and the line-out jack simultaneously.
Interface
Buttons • Power
• Reset
• USB One Touch Copy
IR sensor 1
Dimensions
Form factor Tower
Note
The QNAP RM-IR004 remote control is an optional separate purchase.
Product Overview 5
Component TVS-951X
Dimensions (H x W x D) 182 x 225 x 224 mm ( 7.17 x 8.86 x 8.82 inch)
Net weight 3.53 kg (7.78 lbs)
Other
Power supply unit 120W, 100-240V AC, 50/60Hz
System battery CR2032 lithium battery (3V, 225mAh)
Warning
When replacing the system battery, only use the same battery type as the existing one to avoid explosions.
Sound level 17.6 dBA
Note
The sound level was tested at a bystander position, which is within one meter from the NAS. The test NAS operated at low speed with the maximum number of drives installed.
Fans 1 x 140 mm, 12V
TVS-951X User Guide
Warning
To avoid serious injuries, do not touch the fans while the NAS is connected to a power source.
Operating temperature 0 to 40˚C (32 to 104˚F)
Relative humidity • Non-condensing relative humidity: 5 to 95%
• Wet-bulb temperature: 27˚C (80.6˚F)
Security slot Kensington security slot
Tip
Model specifications are subject to change without prior notice. To see the latest specifications, go to https://www.qnap.com.

Package Contents

Item Quantity
TVS-951X NAS 1
AC power adapter 1
Power cord 1
Ethernet cable 2
Screws for 2.5-inch drives 24
Screws for 3.5-inch drives 32
Quick Installation Guide (QIG) 1

Components

Product Overview 6

Front Panel

TVS-951X User Guide
No. Component No. Component
1 Status LED 5 IR sensor
2 LAN LED 6 Power button
3 USB LED 7 USB One Touch Copy button
4 Drive LEDs 8 USB One Touch Copy port

Rear Panel

No. Component No. Component
1 Reset button 6 USB 3.0 Type-A ports
Product Overview 7
No. Component No. Component
2 3.5 mm speaker jack 7 Kensington security slot
3 10GBASE-T RJ45 port 8 Power input
4 Gigabit Ethernet RJ45 port 9 System fan
5 HDMI Port 10 Speaker

Front Drive Numbering

TVS-951X User Guide

Installation Requirements

Category Item
Environment • Room temperature: 0 to 40˚C (32 to 104˚F)
• Non-condensing relative humidity: 5 to 95%
• Wet-bulb temperature: 27˚C (80.6˚F)
• Flat, anti-static surface with no exposure to direct sunlight, liquids, and chemicals
Hardware and peripherals • Storage drives
For details on compatible drives, go to https://www.qnap.com/
compatibility/.
• Network cable
Tools • Phillips #1 or #2 screwdriver
• Anti-static wrist strap

Setting Up the NAS

1. Place your NAS device in an environment that meets the requirements.
For details, see Installation Requirements.
2. Install the drives.
Product Overview 8
For details, see the following topics:
• Installing 3.5-inch Hard Drives on 3.5-inch Trays
• Installing 2.5-inch Hard Drives or Solid State Drives on 3.5-inch Trays
• Installing Solid State Drives on Solid State Drive Trays
3. Connect the power cord and all applicable cables.
4. Power on the NAS.
5. Install QTS.
For details, see QTS Installation.
6. Log on to QTS.
TVS-951X User Guide
Product Overview 9
TVS-951X User Guide

3. Installation and Configuration

This chapter provides specific hardware and firmware installation and configuration steps.

Hardware Installation

This section provides information on installing drives and memory modules.

Drive Installation

The TVS-951X is compatible with 3.5-inch, 2.5-inch hard drives, and 2.5-inch solid state drives.
Installing 3.5-inch Hard Drives on 3.5-inch Trays
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the NAS.
2. Remove the drive tray.
a. Slide the lock down.
b. Pull the tray handle outward.
c. Pull the tray out.
3. Install a drive on the tray.
a. Remove the fastening panels from the sides of the drive tray.
Installation and Configuration 10
TVS-951X User Guide
b. Place the drive on the tray so that the holes on the sides of the drive are aligned with the holes on
the sides of the tray.
c. Attach the fastening panels to lock the drive to the tray.
d. Optional: Attach the screws to further secure the drive.
Installation and Configuration 11
TVS-951X User Guide
4. Load the tray into the bay.
a. Slide the tray into the drive bay.
b. Push the handle.
c. Slide the lock up.
5. Power on the NAS.
Installing 2.5-inch Hard Drives or Solid State Drives on 3.5-inch Trays
Warning
• Installing a drive deletes all data on the drive.
Installation and Configuration 12
Loading...
+ 30 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use