QMtel QMTQMODEM800P Users Manual

USER’S MANUAL

Q-modem 800P

Palm V series (V/Vx) attachable CDMA modem

Document number: Q-modem 800P010317 Revised: March 17, 2001

CONFIDENTIALITY AND PROPRIETARY INFORMATION

Do not duplicate or distribute without express permission from QMtel Co., Ltd.

Please read this information before use

FCC RF EXPOSURE COMPLIANCE

In August 1996 the Federal Communications Commission (FCC) of the United States
with its action in Report and Order FCC 96-326 adopted an updated safety standard for
human exposure to radio frequency (RF) electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines are consistent with the safety standard
previously set by both U.S. and international standards bodies. The design of this
phone complies with the FCC guidelines and these international standards.

Use only the supplied or an approved antenna. Unauthorized antennas, modifications,
or attachments could impair call quality, damage the phone, or result in violation of FCC
regulations.

This CDMA modem module has been tested for FCC RF exposure hand and body
SAR compliance with the Palm V/Vx handheld organizer. In order to comply
with FCC RF exposure requirements, the CDMA modem module must be operated
with the Palm V/Vx handheld organizer. The use of this device in any other
type of host configuration may not comply with FCC RF exposure requirements
and should be avoided. During operation, a 0.5cm separation distance should
be maintained between the antenna, whether extended or retracted, and the
user’s/bystander’s body (excluding hands, wrists, feet, and ankles) to ensure FCC
RF exposure compliance.

CAUTION

Changes or modifications without the express consent of QMtel Co., Ltd. voids the
user’s authority to use the equipment. This equipment has been tested and found to
comply with the limits pursuant to Part 22of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in an appropriate
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not used in accordance with instructions, can cause harmful radiation to radio
communication. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference in radio and
television reception, which can be determined by turning the equipment on and off, the
user is encouraged to try to correct the interference by one or more of the following
measures:

l Reorient or relocate the receiving antenna
l Increase the separation distance between the equipment and the receiver
l Contact QMtel Co., Ltd. Technical Support for assistance.

Introduction

Q-modem 800P is Palm attachable modem based on CDMA technology. Q-modem 800P supports
wireless data transaction with attachment to Palm V series (Palm V/Vx) on CDMA coverage territory.

General Features

l Ultra compact design & size
l High capable li-ion rechargeable battery pack
l 64kbps data transfer rate support-up to CDMA coverage
l IS-95A/B CDMA Protocol Support
l Wireless e-mail sending & receiving anywhere & anytime
l Wireless Internet access & surfing anywhere & anytime
l Standard RS-232 Interface
l TIA/EIA IS-95A/B(Common Air interface) compatible: Protocol between MS and BTS
l TIA/EIA IS-98A compatible: Minimum Performance Requirements for MS
l IS-707 compatible: Async Data Service
l IS-637 compatible: Short Message Services

Unpacking

1. Q-modem 800P

2. Adaptor

3. Rechargeable battery

Description