Qmark Ceiling Fan Accessories User Manual

®

ASSEMBLY INSTRUCTIONS & PARTS MANUAL

CEILING FAN GUARDS

MODELS: 2800-1 AND 2800-2

Description

The Leading Edge ceiling fan guards are designed to be
used with Leading Edge Commercial/Industrial ceiling
fans. This guard is strongly recommended for use on
fans located in any area where there is a possibility of
objects larger than 3” being thrown into the fan. This
ceiling fan guard is suited for school gymnasiums,
indoor arenas and other public areas. Each unit
consists of 8 (eight) sections, guard, clamp, brace, and
assembly hardware. The guard has a galvanized finish.

General Safety Information

NOTE: Ceiling fan guards to be used in conjunction
with specified fan models only: 52” guard - 3620-1,
4820-1, and 62” guard - 5600-1LC, 5631-1R, 5610-1,
5600-1, 5601-1, 5600-7, 6000-1, 6001-1, 6010-1.

1. Care should be taken to ensure that power source to
fan is locked off before guard is installed so that the
fan creates no hazard to installer.

2. Make sure hanger hooks are mounted securely to
structural ceiling members and must support 150
pound load limit.

3. Make sure guard is securely in place before placing
fan into operation.

READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE, OR MAINTAIN THE PRODUCT
DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!

RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.

Maintenance

WARNING: MAKE CERTAIN THAT THE POWER
SOURCE IS DISCONNECTED BEFORE ATTEMPTING
TO SERVICE OR DISASSEMBLE ANY COMPONENTS!
IF THE POWER DISCONNECT IS OUT OF SIGHT,
LOCK IT IN OPEN POSITION AND TAG TO PREVENT
APPLICATION OF POWER.

CLEANING
This fan guard may be wiped off with a damp cloth. If

already installed on ceiling fan, do not allow the fan
motor to get wet. Do not use solvents or harsh
detergents.

Figure 1

Dimensions

MODEL

NUMBER

DIMENSIONS

AB

2800-1

2800-2

62”

52” 10

3

/4”

10

3

/4”

Figure 2

A Marley Engineered Products Brand

1. Place three guard bottom sections on flat surface
(floor) and connect together in 3/4circle using
enclosed 11/8” bolts, washers, lockwashers and 5/16”
nuts.

(See Figure 3)

Installation

3. With three sections assembled, place 1/2of guard
clamp brace on top section and bolt to top of guard.

(See Figure 5)

Figure 3 - Assemble Bottom Section

Figure 5 - Assemble Clamp Brace

2. Place each of three guard top sections on top of
matching bottom and bolt together using 11/8” and
1

1

/2” bolts, washers, lockwashers and 5/16” nuts. (At
this time do not bolt the 2 top bolts closest to the
center of the fan guard.) (See Figure 4)

Figure 4 - Assemble Top Section

Figure 6 - Install Guard to Fan

4. Insert completely assembled fan with blades
attached into guard and attach steel brace to fan
downrod, leaving

1

/2” between top of canopy and
guard and at least 2” from bottow of motor. Attach
second half of guard clamp to the fan downrod.

(See Figure 6)

LEAVE 1/2” OF SPACE BETWEEN TOP OF
CANOPY AND GUARD AND AT LEAST 2”
FROM BOTTOM OF MOTOR. MAKE SURE
ALL HARDWARE IS SECURE TO PREVENT
GUARD/CANOPY FROM TOUCHING.

IMPORTANT!

2