Qinuo Electronics RF153X User Manual

RF153X Manual

一、 type: Transmitter

二、 IC：SI4010-GS-10pin

三、 Modulation: ASK

四、 The frequency range: 433.92MHz ± 75KHz

五、 The number of channels: 1

六、 Frequency stabilization mode: sound frequency

stabilization

七、 Antenna: on-board PCB antenna 0dBi

八、 Operating voltage: 3V

九、 Working current: 14mA

十、 Photo：

十一、 Operation: The remote control uses HCS301

encoder chip, ensuring every launch of the code

and the last launch of the code is not repeated,

which can prevent the code copied by others,

resulting in security issues. When the user

presses the button shown in the figure, when

shown the LED will light, indicating the success

of this launch, when the user stops pressing the

key after the LED lights burn out, firing

stopped.

FCC ID: QVQ-RF153X

changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.