Page 1
Source/Pair
Adjust the switch to one of
the sources to turn the unit
on. In Bluetooth mode,
press to begin pairing.
USB CHARGER LINE IN
AC IN~
SOURCE/PAIR
OFF
FM
AM
/LINE IN
M
I
N
V
O
L
U
M
E
M
A
X
T
U
N
I
N
G
FM 88 91 94 98 102 106 108 MHz
AM 530 700 900 1100 1300 1500 1700
KHz
• Battery shall not be exposed to excessive heat such as sunshine, or the like.
• Keep new and used batteries away from children. If the battery compartment does not close securely,
stop using the product and keep it away fromchildren.
• If you think batteries might have been swallowed or placed inside any part ofthe body,seek
immediate medical attention.
• Do not mix old and newbatteries.
• Completely replace all old batteries with newones.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
• Batteries should be recycled or disposed of as per state and local guidelines.
FEATURES AND CONTROLS
Bluetooth Wooden Retro Radio
User’s Guide for Model No. RETRO-100
Important Safety Instructions
• Read these Instructions.
• Keep these Instructions.
• Heed all Warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’sinstructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including
that produce heat.
• Do not defeat the safety purpose of the polarized or grounding - type plug. A polarizedplug has two
blades with one wider than the other. A grounding type plug has two blades and athird grounding
prong.
wide blade or the third prong are provided for your safety. When the providedplug does
not
into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
• Only use attachments/accessories
by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to
service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilledor objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
• Use only with a cart, stand, tripod, bracket, or table
by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
FCC Warnings
Warning: Changes or to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
equipment has been teste d and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the F CC Rules.
limits are designed to provid e reasonable protection against
harmful interference in a residential installation.
equipment generates, uses, and can radiate radio
frequency energy a n d, if not installed and us ed in accordance with the instructions, may cause har mful
interference to radio com munications. However, there is no guarantee t hat interference will not oc cur
in a particular i n s tallation. If this equipment d oes cause harmful interfe rence to radio or television
reception, which can b e determined by turning t he equipmen
t
and on, the user is encouraged to tr y
to correct the interfere nce by one or more of the followin g measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit
from that to which the receiveris
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Additional Warnings and Precautions
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
• WARNING: To reduce the risk of or electric shock, do not expose this apparatusto rain,
moisture, dripping, or splashing.
• CAUTION: Use of controls or adjustments or performance of procedures other than those
may result in hazardous radiation exposure.
• WARNING: Changes or
to this unit not expressly approved by theparty responsible
for compliance could void the user’s authority to operate the equipment.
• WARNING: Do not place this unit directly onto furniture surfaces with any type of
porous, or
sensitive
As with any rubber compound made with oils, the feet could causemarks or staining
where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass
between the unit and the surface to reduce the risk of damage and/or staining.
• WARNING: Use of this unit near
lighting may cause interference regarding use of the
remote. If the unit is displaying erratic behavior move away from any
lighting, as it may
be the cause.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace onlywith the same or
equivalent type.
• WARNING:
is a danger of explosion if you attempt to charge standard Alkaline batteries in the
unit. Only use rechargeable NiMH batteries.
• WARNING: Lithium batteries, like all rechargeable batteries, are recyclable andshould be recycled
or disposed of in normal household waste. Contact your local government for disposalor recycling
practices in your area.
should never be incinerated since they might explode.
• WARNING: Shock hazard- Do Not Open.
• Caution and marking information is located at the rear or bottom of the apparatus.
• Objects
with liquids, such as vases, shall not be placed on the apparatus.
• Mains plug is used as disconnect device and it should remain readily operable during intended
use. In order to disconnect the apparatus from the mains completely, the mainsplug should be
disconnected form the mains socket outlet completely.
WARNING: To reduce the risk of electric shock, do not remove cover
(or back). No user-ser viceable parts inside. Re fer servicing to
service personnel.
CAUTION
The exclamation point wit h in an equilateral triangle is intended to aler t the
user to the presence of important operating and maintenance (servicing)
instructions in the lite rature accompanying the a ppliance.
This symbol indicates t hat this product incorporates double insulation
between hazardous mains voltage and user accessible pa r ts.
The lightning with arrowhead symbo l , within an equilateral triangle, is
intended to alert the user to the presence o f uninsulated “dangerous voltage”
within the product’s enclo s ure that may be of
magnitude to
constitute a risk of electric shock to persons.
FEATURES
• 3.5mm audio input
• Analog volume control
• USB port for mobile phone charging
• LED pairing indicator
• Built-in AM/FM wire antenna
• Bluetooth Wireless range: 33 feet
• AC power input: requires an AC power cable (included)
Tuning
Turn to adjust the AM or
FM radio station.
Volume
Turn to adjust the volume.
3.5mm Audio Line Input
USB Charging Port
AC Power Input
Pairing Indicator
RETRO-100 1 11/19/2014 11:35:44 AM
Page 2
RADIO
Playing the Radio
1. Adjust the Source/Pair knob to AM or FM radio mode.
2. Adjust the Tuning dial to tune the radio.
Radio Reception
An AM and FM antenna is built into the radio. To improve radio reception, adjust
the position of the unit.
USB CHARGER LINE IN
AC IN~
Power to unit
Power to device
USB CHARGER LINE IN
AC IN~
POWER & CHARGING
Plug the AC/DC power adapter (included) into the AC Power Input on the unit, and a standard power outlet. The unit can be used to charge mobile devices through a
USB Charging Port in the rear, as seen below (additional USB cable not included).
Using the Audio Input
Requires a 3.5mm audio cable (included).
1. Connect a 3.5mm audio cable to the Line In Input on the unit and the
audio output on an audio device.
2. Adjust the Source/Pair knob to the Bluetooth/Line in setting. Use the native
controls on the connected device to play your audio through the unit.
BLUETOOTH
Pairing a Bluetooth Device for the First Time
1. Adjust the Source/Pair knob to the Bluetooth/Line in setting.
of the unit.
2. Press the Source/Pair knob.
3. Using the native controls on your Bluetooth device, select the ISB313CW in
your Bluetooth settings to pair. If your device requests a password, enter the
default password 0 0 0 0 .
and connecting Bluetooth devices. After initial pairing, the unit will stay
paired unless unpaired manually by the user or erased due to a reset of
the device.
4. When successfully paired and connected, the pairing indicator will display a
solid blue light.
5. If your device should become unpaired or you
it is unable to connect,
repeat the above steps.
LINE IN
Playing Audio Wirelessly
1. To play or pause a selected track, use the native controls on the connected
Bluetooth Device.
2. Audio played through the connected Bluetooth device will now be heard
through the speaker.
RETRO-100 2 11/19/2014 11:35:45 AM
Loading...