QFX PBX-1008 User Manual

www.qfxusa.com

PBX-1008
120V-240V
35W RMS

User Manual for PBX-1008 Portable Speaker

-1-

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER ON
THIS SPEAKER.
THERE ARE NO USER-SERVICEABLE PARTS INSIDE. REFER ALL SERVICING TO A QUALIFIED
TECHNICIAN.
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user
to the presence of dangerous voltage within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to humans.Users should exhibit extra safety when this
symbol appears in this instruction manual and follow all precautions as they are stated.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in this manual.

1- Read these instructions.
2- Keep these instructions.
3- Heed all warnings.
4- Follow all instructions.
5- WARNING: To prevent fire or electric shock, do not expose this equipment to rain or moisture.
Do not store or operate this product near any liquids.
6- Clean only with a dry cloth.
7- Do not store or operate this product near any heat sources such as radiators, heat registers,
stoves, or other apparatuses (including amplifiers) that produce heat. Keep this product in a well
ventilated area.
8- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has
two blades with one wider than the other. A grounding plug has two blades and a round grounding
prong. The wide blade or third prong is provided for your safety. If the provided plug does not fit your
outlet, consult an electrician for the replacement of the ob solete outlet.
9- Protect all the wires connected to this unit from being walked on or pinched, particularly plugs
and the point where they exit from the unit. When removing the cord from the poweroutlet, remove
it by holding the plug, not by pulling the cord.
10- Unplug the unit during lightning storms or when unused for long periods of time.
11- When wiring this unit and all other equipment used in connection to this unit make sure that all
of your equipment is turned OFF.
12- Once installation and wiring is complete power on all your equipment with the volume and level
controls turned DOWN. Once all the equipment in ON slowly raise the volume or level controls to
their proper positions.
13- Before Placing, Installing, rigging, or suspending any product, inspect all hardware, suspension,
cabinets, transducers, brackets and associate equipment for damage. Any missing, corroded,
deformed, or non-load rated component could significantly reduce the strength of the installation,
placement or array. Any such condition severely reduces the safety of the installation and should
be immediately corrected. Use only hardware which is rated for the loading conditions of the
installation and any possible short-term, unexpected overloading, Never exceed the rating of the
hardware or equipment.
14- Consult a licensed, Professional Engineer regarding physical equipment installation,Ensure
that all local, state and national regulations regarding the safety and operation of equipment are
understood and adhered to.
15- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.

Introduction

Congratulations and thank you for your purchase of this QFX Powered Portable PA System
with wired microphone, USB & SD Card inputs. To get the most from your system, we recommend
you review all the information provided in this instruction Manual.

BE SURE THAT YOU HAVE COMPLETELY CHARGED THE BATTERY PRIOR TO FIRST USE
TO MAXIMIZE THE BATTERY'S LIFESPAN.

WARNING!

PBX-1008 REAR PANEL

-2-

PBX-1008

1

3

6

2

4

5

RISK OF ELECT RIC

SHOC K DO NOT OPEN

CAU TION

+

-

PBX-1008 FRONT PANEL

-3-

PBX-1008

1. LINE Input(1/8"): The 1/8” Line Input is designed to connect directly to a mp3 player or any
other stereo level audio device. Please note that there are two LINE Inputs, RCA and 1/8”. If
both the RCA and 1/8”inputs are connected the unit is automatically play from the 1/8” Line
input.

2. AUX Input (RCA): The RCA Input is designed to connect directly to a CD/DVD/TV or any
other stereo level audio device.Please note that there are two LINE Inputs, RCA and 1/8”.
If both the RCA and 1/8”inputs are connected the unit is automatically play from the 1/8” Line
input. To play from the RCA Line input, please disconnect the 1/8” connection from the 1/8”
Line Input.

3.Power Supply: The power switch should be set to the off position before the power supply is
connected.

4.Voltage Selector 120V-240V. Be sure the unit's voltage in the outlet you are using.

5.DC 12V IN is for connecting to 12V external battery if needed.

6.Antenna is for receiving the FM signal. Before use, pull up the telescopic FM antenna. After
use,pack up the FM antenna to better protect it.

-4-

PBX-1008 FRONT PANEL

PBX-1008

231

5

15

4

6

7

8

910

11

12

13

14

1. Previous Track Button: When on USB/SD mode, short press this button to move to the previous
track for USB/SD. Long press this button to reduce the volume for USB/SD.
When on FM mode, short press this button to move to the previous channel. Long press
this button to reduce the volume for FM.

2. Play/Pause Button: The play /pause button will only control the USB flash drive/SD card and FM
inputs.
When on the mode of USB/SD, Press this button to play or pause the track for USB/SD.
When on the mode of FM, press this button to auto scan all channels.

3. Next Track Button: When on USB/SD mode, short press this button to move to the next track for
USB/SD. Long press this button to increase the volume for USB/SD.
When on FM mode, short press this button to move to the next channel. Long press this button to
increase the volume for FM.

4.Input Mode Button: Press this button to toggle between the various inputs (LINE, USB, SD, FM, ).

5. Power Button: Press this button to power the unit on, off or to charge the unit. If the battery needs
to be charged, set the unit to AC and connect the power cable to the rear of the unit. When set to AC,
the unit can also be powered by an external power supply (electrical outlet) even if the battery is
dead. In this case you need to have the unit set to the voltage corresponding to the voltage of the
outlet. To turn the unit off set the power button to OFF. It is recommended to fully charge the battery
prior to using the unit for the first time. It is also recommended to charge the battery at least every

2-3 months to keep the battery operating to it highest capacity.

6. Master Level Control: Turn this knob to adjust the master volume.

7. Treble adjustment: Turn this knob to increase the treble on the LINE/USB/SD/FM inputs

8. Bass adjustment: Turn this knob to increase the bass on the LINE/USB/SD/FM inputs

9. Microphone Echo Knob: Use this knob to adjust the echo for the microphone input(Mic1& Mic2).

10. Microphone Volume Knob: Turn this knob to adjust the microphone volume level of the microphone
input (Mic1& Mic2)

11. Guitar Volume Control: Turn this knob to adjust the volume for the guitar.

12.Microphone Input(1/4"): Connect a microphone to this microphone input terminal.

13. Guitar Input (1/4"): Connect a guitar cable to this input terminal.

14. SD/MMC card slot: Connect your SD/MMC card memory storage (flash drive) device here.
The maximum size of the SD/MMC card can not exceed 8GB. The speaker will only play .mp3 files
from the SD/MMC card input. Do not connect your computer to this input as it will not play files directly
from a computer.

15.USB slot: Connect your USB memory storage (flash drive) device here. The maximum size of the
SD/MMC card can not exceed 8GB. The speaker will only play .mp3 files from the SD/MMC card input.
Do not connect your computer to this input as it will not play files directly from a computer.