QFX BT-600 Product Manual

Product manual

Model No.:BT-600

Operate Instruction

The speaker must be turned on

using any of the following modes.

1. Bluetooth Mode

1 Turn the speaker on，a tone will be emitted to signal that it is ready to
be paired with a Bluetooth compatible device.
2 Setting the Bluetooth of your phone and tablet PC (Please set it
according to your own device）then begin searching Bluetooth mode and find
the paring name “QFX BT-600” to pair.
3 When the match is finished, there will be warning, you can play
the music as you like by then, the searching time is different for

different branded device, it takes about one-minute general condition.
4 To unpair or remove a Bluetooth compatible device from the speaker, turn off the
Bluetooth function on the device, the speaker can be paired with a new compatible
device now.

(Long Push the switch“ ”) before

Note: Once connected, sound can be controlled using either the speaker or
the relevant controls on the Bluetooth compatible device.

2. USB/ TF card Mode

1 To use TF mode, insert a TF card (not included) into the TF card slot on
the back of the speaker. The speaker will automatically change to TF mode.
2 To use USB mode, insert a compatible USB drive into the USB port on the
back of speaker. The speaker will automatically change to USB mode.
3 To add or minus the volume by pressing the"+" button and "-"button
without moving your finger away.
4 To switch the next song by pressing the button “+ ”and last song by the

" - " button shortly.
Note: If the speaker does not automatically change to TF or USB mode, press “M”
until the desired operation is selected.

3.Hand free Mode

1 To make sure your mobile phone and the speaker is connected.

2 When there is calls get in, please press“ ”to answer the call.

3 When you want to hand up the phone, press “ ” again.

4. Aux in Mode

Connect one end of the line in Aux port on the speaker and the other end to
a MP3 player or other compatible audio source.
The speaker will automatically switch to Aux mode once the aux cable has
been inserted.
To change different functions, press the button“M”.

5. FM radio Mode

Connect the micro 5 pin end of the supplied USB charging cable to unit and

the cable will work as external antenna. Press the button “ ” into

FM radio function.

To scan the FM frequency, press “ ” button.
Note: Remove the USB/TF card while using the FM radio function.

6. To charge

Please insert the micro USB end of the charging cable into the port “DC
5V” on the back of speaker. The light keeps on when charging. The light
turns off once full charged.
Carefully disconnect both ends of the USB charging cable and store it
safely for future use.

7. Things need to be careful

1 Please read the manual carefully to make sure the safe of you
and the speaker.
2 Do not use the speaker in the environment of hot, dusty of moist.
3 Please avoid falling or strong bump to keep the surface and
Other hardware in good condition. When do not use the device
for long time, please push the switch to “off”.
4 Please turn off the device when inserting and extracting the
TF card, this may destroy the device and loose the data
on the TF card.

8. Dimension and Features

Output Power:10W (THD=10%)
Battery capacity: 1200mA
Frequency：20HZ-20KHZ
Transferring distance: ≥10meter （let depends on the Bluetooth
device and the environment)