QED ROOMLINK RL-SP3 Installation Manual

ROOMLINK RL-SP3 STARTER PACK

Installation Document

ROOMLINK is designed to offer the benefits of controlling your remote control video or hi-fi system
from any room you choose.

ROOMLINK is derived from the more sophisticated award winning SYSTEMLINE multi-room system,
and as such benefits from the considerable design expertise gained with that project.

ROOMLINK works by allowing the original hi-fi system (or video) remote control handset to be used
from any room you choose, the infra-red codes being received by a wall mounted sensor placed in the
extension room. The sensor then relays the codes back to the equipment in the main room. In addition
to the sensor, a speaker on/off switch or Speaker Volume Control is normally fitted in the extension
room, as this allows local control over sound selection. (see section 3 for examples).

NOTE: "Please note that a small number of IR codes will not pass through Roomlink successfully.

Please ensure complete operation before running wires and installing back boxes etc."
ROOMLINK is not suitable for use with most B&O and some satellite and cable equipment, as their infra­red carrier system operates at a non-standard frequency.

STARTER PACK 3 CONTENTS

ROOMLINK is available as a starter pack which incorporates the following:

1) ONE x ROOMLINK DRIVER

2) TWO x FLOOD EMITTERS (SL-FE)

3) ONE x PLUG TOP POWER SUPPLY (UK ONLY)

4) ONE x ROOMLINK SENSOR (including plug-in connector)

5) TWO x WINDOW EMITTER PACKS (SL-DE)

3 INSTALLATION EXAMPLES

BASIC CONNECTION

ROOMLINK DRIVER

MAINS

WM22

IR RECEIVER

EQUIPMENT TO
BE CONTROLLED

MAIN ROOM

WIRING OPTIONS FOR MORE THAN ONE WM22

WM22 WM22

WM22

ROOMLINK DRIVER

REMOTE HANDSET

REMOTE ROOM

STAR WIRING

ALL DATA CABLES RETURN

TO DRIVER INDIVIDUALLY

WM22

WIRED IN SERIES

ALL WM22 WIRED IN

SERIES

CAN BE USED.

WM22

WM22

WM22 WM22

NOTE: A COMBINATION OF STAR

WIRING AND SERIES WIRING

ROOMLINK DRIVER

With the ROOMLINK starter pack, only one pair of speakers plus the appropriate cabling needs to be added to
achieve a basic fully operable extension room system.
Additional rooms may be serviced, by purchasing extra ROOMLINK SENSORS (WM22) as required. A maximum
of eight Roomlink sensors is the limit for any installation, using the M12VDC 1A supply.