Pyle view LCD Monitor PL71PHB, PL1101HRBK, PL1101HRGR, PL1101HRTN, PL72HRBK Instruction Manual

PL71PHB

Instruction Manual

PL7 1PHB

AV MENU MODE POWER IR

Pair of Adjustable Headrest with Built-in 7" TFT-LCD Monitors

H T T P : / / W W W . P Y L E A U D I O . C O M

Warning

Read this manual before using this product.
This product is composed of precision components
and should not be dissembled Service must be
perfurmed by a factory authorized technician.
Protect the product from moisture and shock.

Attentions:

1. When connect the electric power wires, you should make clear about the
positive and negative electrode ( the red one is positive and the black
is negative). If you wrongly connected the fuse in the filter box will be
broken protectively. Please replace the fuse in same parameter.

2. Because the LCD screen is the main component It should be paid
attention to be damp-proof.

3. The device must be installed firmly to prevent falling of device that will
possibly cause injury and device-broken.

4. The connecting-point of direct current (12V) should connect on the Main
line of storage battery as possible as it can , for keeping this device in
normal operation and be away from the large voltage drop influence.

5. There is high voltage cluster in this machine, if you are the professional
person, should never to take part the machine if malfunction and
contact the dealer in time.

1

UNIVERSAL

HEADREST

MONITOR OWNER'S MANUAL

WITH

PRE-INSTALLED

Congratulations
product
lasting high performance. For best results please consult a professional
mobile electronics installer for application advice
Please read these instructions thoroughly before installation.

is

designed and built to deliver excellent video quality and long

on

your purchase

of

this headrest monitor system. The

or

troubleshooting.

Installation Instructions

1.

Remove the existing headrest from the seat.

2. Adjust the posts of the new headrest to fit the holes in the seat where
be

the headrest will
apart: grasp one post
directions (like they were walking) while pushing them toward each
other or away from each other.

3.

Insert the cable

in

installed. The post can

in

each hand, move the posts

the proper hole. Insert the posts into the holes

be

moved together or

in

opposing

in
the seat and carefully work the headrest into position. Make sure the
cable

4. Run the cable down the seat and out to the location of the video
source unit (such as a

5.

Connect the wires as indicated:
a.

b.
c.

d.

is

not pinched.

DVD

Red: Connect to a switched (+) 12 volt source (ACC). Use a lead
that has
the monitors turn off when the key
monitors "hot" could cause your battery to
engine is not running.
Black: Connect to a good chassis ground.

Reversing the polarity of the
monitor.

Connect the video input connector to the video output from the

source unit (Le.DVD player).

(+) 12V when the ignition is

player).

red

on

or

in

the ACC position so

is

in

the off position. Wiring the

run

down when the

and black leads will damage the

e.

Test the system.

2