PYLE Audio PWMA820 User Manual

PWMA-820

OPERATING INSTRUCTIONS

SINGLE VHF WIRELESS

BATTERY POWERED PA SYSTEM

WITH MP3 PLAYER

WWW.PYLEAUDIO.COMWWW.PYLEAUDIO.COM

GENERAL DESCRIPTIONS

PARTS DESCRIPTION

1. This ALL-IN-ONE karaoke system is suitable for karaoke, meeting,
schools, presentation, aerobics etc.

2. Built-in 512MB MP3 player. With USB port which can play flash
drive, Mp3 player etc. With SD/MMCcard reader. With 3.5mm
AUX in jack which can connect with iPod, CD player etc.
With recording function.

3. 8" woofer and 3" tweeter. 150WRMS, 300W peak power.

4. Built-in one set of wireless microphone.

5. Two MIC-IN, one guitar in and one 6.35mm audio in jacks.

6. Built-in 7AH/12V rechargeable battery which can work
continuously for about 4 hours. Suitable for indoor and outdoor
activities.

7. Treble, bass and echo controls

8. 110V/220V voltage switchable.

9. Telescoping handle and caster wheels. Easy for transportation.

IMPORTANT SAFEGUARDS

1. Correct power must be used. Don't use any other power

except the specified one.

2. Don't drag the power cable when pull out the plug. Hold the

plug to pull it out from socket.

3. Don't open chassis: it is very dangerous either open the

chassis or put your hand inside the chassis. If the device is

not under normal working, pull out the plug at once and contact

your retailer or the nearest distributor.

4. Don't take volatile solvent such as toluene, alcohol, gasoline to

clear the surface.

5. Please don't put it in an unventilated environment or at direct

sunlight in summer.

6. Avoid moisture or rain.

1. Metal corner for protection

2. Input jack for Mic 1

3. Input jack for Mic 2

4. RF signal indicator

5. Charge indicator

6. Low battery indicator

7. Power indicator

8. Power switch

9. GUITAR INPUT 1

10. Audio input jack

11. Guitar volume control

12. Audio volume control

13. Grille

14. Woofer

23

2122

1

2

10

11

12

13

14

3

4
5
6
7
8
9

DIGITAL MP3 PLAYER

MENU MENU ENTER ENTER PLAY/PAUSE PLAY/PAUSE PREVIOUS PREVIOUS NEXTNEXT RECORDRECORD

USB USB AUX INAUX IN

SD/MMCSD/MMC

FLASH DRIVERFLASH DRIVER

15. Tweeter

16. MP3 player

17. Bass control

18. Treble control

19. Echo control

20. Mp3 volume control

21. Master volume control

22. W/MIC 1 volume control

23. MIC 2 volume control

24. Trolley

25. Handle

26. 110V/220V voltage switch

27. AC IN

28. Fuse

17

181920

16

15

29

24

25

26
27

28

220V

110V

AC

+

FUSE

---1---

---2---

OPERATION

OPERATION

1. POWER SUPPLY

1) AC Power: Before operation, please confirm the voltage is same

as the specified one marked on the label.

2) Built-in Rechargeable Battery: You can use built-in rechargeable

battery without plug in AC power.

3) When the Low Voltage Indicator comes on yellow, it indicates the

battery voltage is low. Please plug in AC power to charge the

battery. When battery is fully charged, low voltage indicator will

extinguish.

4) If the unit is not going to be used for a long time, please charge

the battery every 2 months. Charging time is 8-10 hours for each

time.

2. OPERATION OF AMPLIFIER

1) Use provided AC cord to connect this unit to suitable power

socket. Pay attention to the voltage. Charge indicator will light.

Or use built in battery.

2) Turn on amplifier power switch, power indicator comes on red.

7) To play guitar, connect guitar to GUITAR IN jack. Guitar volume

can be adjusted by Guitar Volume control.

8) External audio device can also be connected to AUDIO IN jack.

Audio volume can be adjusted by AUDIO volume control.

9) To play MP3 player, refer MP3 player instruction.

3. OPERATION OF WIRELESS TRANSMITTER

1) Insert attached 9V battery into wireless transmitter.

2) Insert headset MIC or clip-on MIC to body pack transmitter

MIC-IN jack. Adjust body pack transmitter volume switch to

suitable level.

3) Move Power Switch to ON position. Power indicator will flash

once then extinguish. RF indicator on amplifier will light to

indicate receiving signal. Now you are ready to talk.

4) To mute the sound, move power switch to middle.

5) To turn off the transmitter, move power switch to OFF position.

6) If Power indicator of wireless transmitter lights red, it indicates

the battery power is low. Please replace new battery.

3) Adjust MASTER volume control to suitable level.

4) Turn on handheld microphone, RF indicator on receiver will

light. Wireless microphone volume can be adjusted by

W/MIC 1.

5) Adjust BASS, TREBLE and ECHO to the suitable level. Now you

are ready to talk.

6) Wired microphone(not included) can be connected to MIC 1 and

MIC 2 jack. MIC volume can be adjusted by W/MIC 1 and MIC 2

volume control respectively. You can use the wireless MIC and

the two wired MIC at the same time.

---3---

1

3

2

3

4

4

5

2

(Optional) (Optional) (Optional)

1. MIC grill(capsule inside)

2. Power indicator

3. Power Switch

6

Headset MIC

4. Battery cover

5. Volume control

6. MIC-IN jack

---4---

Lavalier MIC