PYLE Audio PWLB006 User Manual
Step 4
Step 4
Carefully position monitor so that Wall and
Monitor Plates are vertically aligned, with the
bottom of Monitor plate overlapping the top of
the Wall Plate by approximately 1”.
Gently lower monitor into position, sliding the
two plates together until the Monitor Plate
bottoms out. (Fig. 3)
Caution:
Caution:
onbothsidesofthemountbeforereleasinggrip
on monitor.
Step 5
Step 5
Install two Safety Bolts (3) through bottom of Wall Plate.
(Fig. 3)
Caution :This Product LCD /Plasma Wall Mount Bracket is
Caution :
intended for use only with the maximum weights indicated .See apparatus
instructions .Use with products heavier than the maximum weights
indicated may result in instability causing possible injury .
Make sure that the plates are engaged
Fig 3
1
2
3
Flat Panel Fixed Mount
INSTALLATION GUIDE
Item No.:PWLB006Item No.:PWLB006
-4-
TV Size Rang 10 24:"-"
Universal VESA mount
Low profile: only from wall17mm
Easy to install: sliding plate operation
Max load capacity:15Kg/33lbs
IMPORTANT: If don’t understand about right install ways, please
IMPORTANT
consult to normal installing specialist.
Parts:
2
Step 2
1
Letter
1
2
3
A
B
C
D
E
F
G
3
A
B
D
C
H
I
E
Qty
1
1
2
4
4
4
4
4
6
4
2
2
F
G
Description
Monitor Plate
Wall Plate
M5x10 Safety bolt
M4x8 bolt
M4x12 bolt
M5x8 bolt
M5x12 bolt
14-20x58bolt//””
M5 washer
M6 washer
Long bolt
Wall anchor
H
I
Step 2
Wooden Stud Mounting:
Wooden
Stud Mounting:
Using an electronic stud finder, locate the center of the wooden stud.
Position the Wall Plate (2) in desired mounting location over stud.
Level the Wall Plate with a bubble level, and then using the wall plate
as a template, mark mounting hole locations over the center of the stud.
Drill 2 mounting holes 50mm deep, into the stud using a 3mm drill bit.
Masonry Mounting:
Masonry Mounting:
Position the Wall Plate (2) in desired mounting location on wall.
Level the Wall Plate with a bubble level, and then using the wall plate
as a template, mark mounting hole locations on wall.
Drill 2 mounting holes 50mm deep, using a 8mm masonry bit. Insert
Wall Anchors (I) into the mounting holes, and lightly tap them flush to
the wall with a hammer.
Caution:
Caution:
NEVER
NEVER
Wall Anchors should only be used for masonry mounting.
use wall anchors to mount the mount to drywall.
Securely mount Wall Plate with supplied Long Blot (H) and washer(F).
Step 3
Step 3
Step 1
Step 1
Determine the desired location
for the monitor.
Important
Important
Make sure there is
:
adequate mounting space
available for the monitor,
considering the monitor dimensions.
This mount is supplied with the
necessary hardware for either
Wooden Stud Mounting or
Masonry Mounting. Determine
your mounting type and proceed accordingly.
-2-
Fig 1
Attach Monitor Plate to back of the monitorwith 4mm, 5mmor 1 4”-20x5 8”
//
supplied hardware. (A-E) (Fig. 2) Check the monitor’s owners manual
for correct length screw to use.
Caution:
Caution:
Never force screws into the monitor, as damage may occur.
G
F
A,B,C,D,
E
Fig 2
-3-
Loading...