Specifications and Main Features
- Supply Voltage: 110V 60Hz / 220V 50Hz
- Total Power Dissipation: 65W
- Remote Control Battery Type: 3-V lithium button cell CR2032
- The portion of the remote circuitry that replaces the backup battery: F1AH250V (5*20mm)
- Input Volume: 400mV
- Total Output Power:
- 12W RMS of a power amplifier for use with an 8 Ohm load
- 15W RMS of a power amplifier for use with a 4 Ohm load
- 2-channel surround sound with 6w RMS speaker output at 8 Ohm
- Distortion level: ≤0.1%
- Frequency slope: 20-20,000 Hz
- Signal-to-noise ratio: >70dB(A)
- Separation Between Channels: 40dB
- Audio EQ: Bass +/- 10dB@100Hz Treble +/- 10dB@10KHz
- Dimensions: 63 x 180 x 150 mm
- Mass: 1.9 kg
Frequently Asked Questions
Q: Are there any loudspeaker restrictions in attaching one to the amplifier?
A: Increase the impedance for each channel only to 4 Ohms before fixing loudspeakers.
Q: The device allows me to insert USB sticks, are there any differences with hard disks?
A: Hard disks that USB plugs connect to this device are not able to be used.
Q: What Could Be The Possible Causes For No Sound Coming From The Amplifier?
A: Possible reasons could be device in the playback chain is not turned on, wrong input is selected , VC is at minimum or fuse is busted.
Q: Is It Necessary To Be Careful Of Where The Amplifier Is Used?
A: No, only allowed to be used in closed rooms indoors. It is prohibited to use it outside.
Q: If The Remote Control Stops Working Is There Any Action One Could Take?
A: Most likely the battery could have dischrged, in this case it should be replaced to 3V lithium button cell CR2032.
Q: Can SD/MMC Cards Above The Storage Of 2GB Be Usable?
A: No, it does not support SD/MMC cards greater than 2GB as well SDHC cards as well.
Q: With The Knowledge Of Amps Would One Be Able To Maintain And Look After An Amplifier On Their Own?
A: Chceck that the power cable is not damaged and the housing is also intact, turn off all voltages to it and it is advised to maintain.
User Manual
Loading...