PYLE Audio PPDLUW2 User Manual

PPDLUW2

AUTO-WAH

CONTROLS

1. The RATE control determines the speed of the Wah effect
modulation.

2. The DEPTH control adjusts the sweep range of the effect.
At minimum position no modulation effect is produced and
the Wah effect is controlled by your playing intensit y only.

3. The MANUAL control adjusts the basic frequency where
the effect starts working. High MANUAL settings will decrease
the sweep range, because the low end of the frequency
sweep is moved upwards.

4. The SENS control adjusts the sensitivity of the effect.
Nearing maximum position you achieve Wah effect even with
soft playing, nearing minimum position the Wah effect will not

be dependent on your playing dynamics

5. The ON/BATT LED illuminates when the effect is
activated. It also serves as a battery level indicator.

6. Use the Footswitch to activate/deactivate the effect.

7. Use this 1/4 TS IN connector to plug in the instrument cable.

8. The 1/4 TS OUT connector sends the signal to your amp.

Use the DC IN connection to plug in a 9v power supply (not included). The Battery Compartment is

located underneath the pedal cover. To install or replace the 9v battery, press the hinges with a pen

This effects pedal has no on/off switch. As soon as you insert the jack into the Input connector, the
pedal will turn on. When not in use, remove the jack from the input connector to save the batteries.

SPECIFICATIONS

Input Connector: 1/4 TS Impedance 500k
Output Connector: 1/4 TS Impedance 1k
Power Supply: 9V, 100mA DC regulated
Power Connector: 2mm DC Jack, Negative Center
Battery: 9v Type 6LR61
Power Consumption: 30mA
Dimensions: 4.9”D x 2.76”W x 2.12”H
Weight approx. 0.33kg (0.73lbs)

SAFETY INSTRUCTIONS

Do not use near water, or install near heat sources. Use only authorized attachments / accessories.
Do not service product yourself. Contact our service department with any questions or to schedule
repair service.

.

and remove the pedal cover.

www.pyleaudio.com