PYLE Audio PLTV7.5DIN User Manual

MOTORIZED 7” WIDE TFT LCD MONITOR

WITH COLOR TV

MODEL NO. : PLTV7.5DIN

ANY CHANGES OR MODIFICATIONS IN CONSTRUCTION OF THIS UNIT

DEVICE WHICH IS NOT APPROVED BY THE PARTY RESPONSIBLE FOR

COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE

THE EQUIPMENT.

WARNING

DO NOT WATCH MONITOR WHILE DRIVING

CONTENTS

WARNING CAUTION UNIT

1. MONITOR

2. REMOTE CONTROL

3. REMOTE CONTROL BATTERY

BASIC OPERATION

1. POWER ON/OFF

2. OPENING THE MONITOR

3. CLOSING THE MONITOR

4. ADJUSTING TILT POSITION

5. ADJUSTING MOVE POSITION

6. ADJUSTING LEFT/RIGHT VIEWING POSITION

7. SELECTING MODE

8. AUDIO MUTE

9. ADJUSTING VIDEO PICTURE MODE (ASPECT)

10. SELECTING THE MENU

FUNCTION

1. FM TRANSMITTER CONTROL

2. TILT POSITION CONTROL

3. MOVE POSITION CONTROL

CONTROL

1. NAVIGATION AUDIO

2. WATCHING NAVIGATION

3. SETTING THE CAMERA IN

4. WATCHING THE REAR VIEW

5. WIRING CONNECTION

6. CAMERA ANGLE CONTROL

7. SCREEN ASPECT CONTROL

PICTURE

1. CONTRAST CONTROL

2. BRIGHT CONTROL

3. COLOR CONTROL

4. TINT CONTROL

5. DIMMER CONTROL

WATCHING TV

1. MENU CONTROL

2. CHANNEL CONTROL

3. FINE TUNING CONTROL

4. AUTO MEMORY

5. CHANNEL SEARCH WARNING SCREEN INSTALLATION BASIC CONNECTION CONNECTING TO AV SOURCES SPECIFICATIONS TROUBLE SHOOTING

WARNING

The exclamation mark in triangle and WARNING mark are intended to alert the user to the

important operating instructions. Wrong operations will result in severe injury to the unit.

DO NOT WATCH MONITOR WHILE DRIVING

Watching the video while driving may interrupt driving and may cause an accident.

DO NOT OPERATE ANY FUNCTION THAT TAKE YOUR ATTENTION AWAY FROM DRIVING YOUR

VEHICLE

Operation of some functions for this unit is very complicated. Because of this, it is necessary

to put these functions into a special SETUP screen. This will restrict operation of these

functions only when the vehicle is parked. This is to make the driver’s attention to the road

and not to this unit. Any function that requires driver’s attention for a long time should be

performed only after you stop the car. Always stop the vehicle in a safe place before

performing these functions. Performing these functions while driving may result in a serious

accident.

DO NOT DISASSEMBLE

Attempts to disassemble may lead to an accident, fire and / or an electric shock.

KEEP SMALL ARTICLES OUT OF REACH OF CHILDREN

Keep small things (screws etc.) in places not accessible to children. If swallowed, consult a

physician immediately.

FUSE REPLACEMENT

When replacing the fuses, the replacement must be the same amperage as shown on the fuse

holder. If the fuse(s) blow more than once, carefully check all electrical connections for short

circuit, also have your vehicle’s voltage regulator checked.

DO NOT USE IMMEDIATELY IF A PROBLEM APPEARS

When a problem appears, stop using the system immediately and contact the dealer from

whom you purchased the equipment.

CAUTION

DO NOT RAISE THE VOLUME EXCESSIVELY

Keep the volume at a specific level which you can still hear outside noise while driving .

Keeping the volume loud may cause an accident.

DO NOT USE THIS EQUIPMENT OUTSIDE THE VEHICLE

Do not use this equipment for purpose other than those listed for a vehicle.

Failure to do so may result in an electric shock or an injury.

HOW TO USE THE BATTERIES

Do not mix new batteries with old batteries and do not replace with other than specified

batteries. When inserting the batteries, be sure to observe proper polarity (+ and -) as

instructed. Battery rupture or chemical leakage can cause an injury or equipment malfunction.

TEMPERATURE

Be sure the temperature inside the vehicle is between +60℃ (+140℉) and –5℃(+23℉)

before turning your unit on.

MAINTENANCE

If you have problems, do not attempt to repair the unit yourself. Return it to your dealer who

you purchased it from.

INSTALLATION LOCATION

Make sure the unit will not be exposed to :

▶Direct sun & heat

▶High humidity

▶Excessive dust

▶Excessive vibration

UNIT

1. MONITOR

2 3

1. POWER ON/OFF / MODE BUTTON

2. OPEN/CLOSE BUTTON

3. TILT UP/DOWN BUTTON

4. MENU BUTTON

5. SEARCH UP/DOWN BUTTON

2. REMOTE CONTROL

3. REMOTE CONTROL BATTERY

. POWER ON/OFF BUTTON

. TILT UP/DOWN BUTTON

. OPEN/CLOSE BUTTON

. MODE SELECTION BUTTON

. SOUND MUTE BUTTON

. NAVIGATION BUTTON

. ASPECT SELECTION BUTTON

. SEARCH UP/DOWN BUTTON

. VOL ◀ / ▶: TILT UP/DOWN BUTTON

0. MENU BUTTON

1. MANUAL SEARCH BUTTON

1 U R M

2. A TO SEA CH/ AUTO EMORY BUTTON

13. BAND SELECTION BUTTON

4. NUMERIC BUTTONS

- Do not insert battery in the wrong direct

- Be sure to observe the correct polarity (+/-) a

ion.

s indicated in the

battery compartment.

- It is dangerous to charge/heat/open or short circuitry the battery.

- Please remove the battery in case of not using the remote control f

or a long period of time.

- It is time to replace the battery if the remote control does not work properly or if the

operating range becomes reduced.

- Should battery leakage occur, cle

an the battery compartment with a soft cloth and replace

with a new battery.

INCORRECT BATT

ERY USEAGE MIGHT CAUSE EARLY DISCHARGE, LEAKAGE OR

CORROSION DAMAGE.

SING THE REMOTE CONTROL

- The remote control should be aimed directly towards the remot

e sensor of the Unit.

- Avoid dropping the remote control.

- Avoid spilling liquids on the remote c

ontrol or exposing it to extreme

heat.

- The remote control should be pointed at the remote sensor in order

for the Unit Monitor to function correctly.

- t of the remote sensor.

Distance: Maximum of 16 feet from the fron

- Angle: Approximately +/-30 from center.

- Please do not locate the Unit where direct

sunlight or fluorescent

illumination might shine directly at the remote sensor.

BASIC OPERATION

1. POWER ON/OFF

) POWER ON

(1) Press the

POWER button on the unit or on the remote control to turn the power on. But

the monitor will not be opened and you can listen to the sound of this unit.

(2 ower will be

) You can also turn the power on by pressing the OPEN/CLOSE button. The p

on and the monitor will be opened.

2) P

OWER OFF

(1) Press the POWER

ff.

f you turn the power off by pressing the POWER button when the monitor is opened, the

(2)I

button on the unit or on the remote control again to turn the power

monitor will be closed and it will be turned off. If the car key is pulled out, the monitor will

be closed automatically.

2. OPENING THE MONITOR

ress OPEN/CLOSE button, the monitor will be opened.

OTE

If OPEN/CLOSE button is pressed with the monitor closed and powered off, the monitor will

be opened and the power will be turned on.

3. CLOSING THE MONITOR

) r on the remote control. The monitor will be

Press OPEN/CLOSE button on the unit o

closed.

2) If it

is not closed, hold left and right upper side of the monitor and make the monitor

parallel with the unit as the picture. And press OPEN/CLOSE button to close the monitor.

OTE

1) If the monitor is not parallel to the front of the unit, the monitor will not be closed.

2) If OPEN/CLOSE button is pressed while the unit is powered on, the monitor will be

closed

but the power is still on. Press the POWER button to turn the power off.

4. ADJUSTING TILT POSITION

he tilt position can be adjusted in 5 steps by pressing TILT UP/DOWN buttons. Each time

you press TILT UP button, the monitor will swing one step backward and each time you

press TILT DOWN button, the monitor will swing one step forward.

OTE

The TILT position also can be adjusted by pressing VOL ◀ / ▶ buttons on the remote

control.

+ 21 hidden pages

PYLE Audio PLTV7.5DIN User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual