Pyle Audio PL-CMDVR72 Owner's Guide



PLCMDVR72 MANUAL





















Please read instructions carefully before installation and use. Installation

should be performed by a professional installer.To ensure your safety, the

driver should not watch videos or operate features on the monitor while

driving. There are noserviceable parts in this unit, do not disassemble or

try to repair this unit. If the unit malfunctions please return to yourvendor

or send to a Pyle repair facility. Please observe and obey the local laws

and regulations when installing the unit.

Upon Installation, please make sure as to not to interfere with any of the

vehicle's safety features, wiring, components, etc.We are not responsible

for any damages, injury, malfunctions or otherwise noted due to faulty or
non‐professionalinstallation.

wires to assist in the video camera system setup.See the wiring diagram

for connections between cameras, monitor and your vehicle.

PLCMDVR72 INTRODUCTION

This model is with one 7 inch quad monitor with RCA jack, and with 2

mini DVR recorder, and with one super slim license plate backup camera.

The 2 mini DVR and backup camera can connect to the 7 inch quad

monitor for display. The mini DVR need to insert the TF card( we

suggest use class 10 TF card), can be installed one DVR for front view

recorder, and the other DVR can be installed for inside of the car

recording. The super slim bar style backup camera is for reverse and

parking.



Monitor Wiring & Connection

Red and black wire is for 12V power

Green wire is Reverse trigger cable

The 2 yellow RCA jack and red and white RCA jack is the 4 ch video

input.





The Reverse trigger cable is for the Ch1, so please connect the reverse

backup camera to the Ch1, so when the truck in reverse status, the reverse

camera would be priority.