Page 1
INSTALLATION
DASH BOARD
METAL MOUNTING STRAP
HEX NUT
SPRING WASHER
PLAIN WASHER
PLAIN WASHER
TAPPING SCREW
CONSOLE
SLIDE BRACKET HOUSING
HEX BOLT
PLCD26
INSTRUCTION MANUAL
Please remove both bolts
which protect the core before
use.
KEY PLATE
KEY PLATE
PLASTIC TRIM OUT
7
OPEN
TUNE
CLK
-
HOUR
CD/RECEIVER&ACTIVE DISPLAY
MIN
SEL
+
VOL
PWR
BD
INT
MO
MU
RPT
RDM
LOC
LUD
COMPACT
DIGITAL AUDIO
EQ
160WATTS
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM
AUTO-LOADING COMPACT DISC PLAYER
AM/FM STEREO WITH MANUAL TUNING RADIO
www.pyleaudio.com
Page 2
LOCATION AND FUNCTION OF CONTROL
1 2 3 4 5 6
-
HOUR
MIN
SEL
+
VOL
PWR
BD
CD/RECEIVER&ACTIVE DISPLAY
INT
MO
MU
RPT
RDM
LOC
LUD
7 13 8 9 10 11 12 14
1. CD ( CD PLAY, PAUSE) BUTTON
At tuner mode, press button to switch to CD mode. At CD mode,
press it to pause the CD program and press it again to resume CD
playback.
COMPACT
DIGITAL AUDIO
EQ
TUNE
CLK
OPEN
Speaker Connection
ANTENNA PLUG
12 P
MEMORY B+
BLACK(GND)
RED (B+)
FRONT
YELLOW
BLUE AUTO ANT
LEFT
SP
REAR
FUSED
FILTER
BOX
0.5A &7A
FUSES
++
WHITE
WHITE/BLACK
++
GREEN/BLACK VIOLET/BLACK
RCA LINE OUT
GRAY
GRAY/BLACK
VIOLETGREEN
++
++
RED R
WHITE L
FRONT
RIGHT
SP
REAR
SPECIFICATION
GENERAL
Power requirement................................................................................................DC 13.8V.
Current consumption..............................................................................................7A MAX.
2. TRACK UP/DOWN BUTTONS
a. During CD mode, press button allow you to track backwards.
Hold the button allow you to skip backwards.
b. During CD mode, press button allow you to track forwards.
Hold the button allow you to skip forwards.
3. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTON
Press SEL button to change the mode in the sequence of
VOL BAS TRE BAL FAD
a. The volume level can be adjusted at any time by pressing the audio level+ or
- button as select mode has been initially defaulted at volume mode.
b. The volume level is also obtained by stepping through the SEL button until
the function VOL is displayed and then press + or - button to adjust the
sound level.
c. Press and hold the + or - button to adjust the sound level.
BASS CONTROL
a. Press the SEL button to select the bass mode until BAS appears on the display.
b. Press + or - to adjust the bass effect.
Power output.........................................................................................................4 X 40W
FM SECTION
Frequency range....................................................................................88MHz -108.0MHz.
Usable sensitivity.........................................................................................................10uV.
I.F Frequency........................................................................................................10.7MHz.
AM(MW) SECTION
Frequency range.....................................................................................530KHz - 1700KHz.
LINE - OUT [OPTION]
Output................................................................................250mV @ FM 10% THD POWER.
Impedance............................................................................................................600 ohm.
CD PLAYER
System........................................................................................compact disc audio system.
Usable disc......................................................................................................compact disc.
Signal format.............................................................................sampling frequency 44.1KHz.
No of quantization bits 1bit.
Frequency characteristics...............................................................................5-40Hz < 5dB
10K-20KHz < 5dB.
Signal to noise radio................................................................60dB [1KHz] [IEC - A net work].
Chassis dimensions.......................................................................178[W] X 50[H] X 159[D].
Page 3
TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Symptom
No power
Disc cannot
be loaded or
ejected
No sound
Sound skips
The radio does
not work
The antenna cable is not
connected
the signals are too weak
Cause
The car ignition is not on. If the power supply is properly
The fuse is blown
Presence of CD disc inside
the player
Inserting the disc in upside
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Volume is in minimum
Wiring is not properly
connected
The installation angle
is more than 30 degrees
The disc is extremely
dirty or defective
connected to the car accessory
switch the ignition key to " ACC "
Replace the fuse
Remove the disc in the player
then put a new upward
Insert the compact disc with
the label facing upward
Clean the disc or try to play a
new one
Cool off until the ambient
temperature returns to normal
Leave the player off for an
hour or so, then try again
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle
to less than 30 degrees
Clean the compact disc/try to
play a new one
Insert the antenna cable firmly
select a station manually
Solution
TREBLE CONTROL
a. Press the SEL button to select the treble mode until TRE appears on the display.
b. Press + or - to adjust the treble effect.
BALANCE CONTROL
a. Press the SEL button to select the balance mode until BAL appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
left or right speaker.
FADER CONTROL
a. Press the SEL button to select the fader mode until FAD appears on the display.
b. Press the + button or - button to increase or decrease the sound level of
front or rear speaker.
4. LCD ( LIQUID CRYSTAL DISPLAY)
5. TUNING BUTTON
During tuner mode, rotate it to select your desired radio broadcasting
station within FM/MW.
6. OPEN BUTTON
Press it to flip down the front panel when you want to take away.
Press it to flip down the front panel then you can insert a disc into the
compartment or eject the disc by pressing the EJ button.
7. POWER BUTTON
Press it to turn on or off the unit.
8. BAND BUTTON
At CD mode, press it to switch tuner mode.
Press it to select your desired radio band and the band which is selected
will be displayed on LCD.
9. MUTE BUTTON
Press it to eliminate the sound temporarily when you need, press it again
to resume normal play state.
10. MO/INT BUTTON
MO MODE: Press it to select mono or stereo mode.
INT MODE:
During CD mode, press " INTRO "button to hear the first 10 seconds
of each track on the disc. Press this button again to restore the
player to its normal play mode.
Page 4
11. LOC/RPT BUTTON
LOCAL/DISTANCE MODE:
When in the radio mode, press them to select local or distance broadcast
station receive sensitivity. The word LOC will appear on LCD during local
state.
Attention: During AM mode, LOC is non-functional.
REPEAT MODE:
During CD mode. Press RPT button to repeat a single track.
12. LUD/RDM BUTTON
LUD MODE:
When reduce the volume to half level, press it to enhance the bass effect.
RDM MODE:
During CD mode, press " RDM " button and hold for 2 seconds,
it display " RDM " and Random function performs.
13. EQ BUTTON
Press it to switch between 4 preset equalizer curves: FLAT, POP, CLAS,
ROCK. The sound quality will be changed.
14. CLOCK ADJUSTMENT BUTTON
During frequency display, press it to change to clock function.
Press the button for more than 2 seconds, until time flashes. and you can adjust
time now.
Press the tune button or continually to adjust Hours and Minutes, when
adjustment is completed, press CLK button to resume normal play state and retain
the adjustment
IMPORTANT:
MEMORY WIRE ( FOR BACKUP) AND POWER WIRE CAN NOT BE SWITCHED
OFF AT THE SAME TIME, ONCE IT HAPPENS, ALL THE FUNCTION WILL BE
TOTALLY IN DISORDER (DISTORTED DISPLAY IS ALSO INDICATED ).
IF IT REALLY HAPPENS,
PLEASE FOLLOW THE INSTRUCTIONS AS MENTIONED
BELOW:
5 MINUTES LATER,
PLEASE SWITCH ON THE MEMORY WIRE FIRST (CAN NOT
PASS THROUGH IGNITION SWITCH) AND THEN SWITCH ON THE POWER. IT WILL
RETURN TO NORMAL FUNCTION SOON.
DISC PLAY:
Cleaning discs
Before playing, clean the disc with a clean, lint-free.
Flip the disc in the direction of the arrow.
NOTE:
. Do not use so solvents such as benzine, thinners. Commercially available
cleaners or anti static spray damage the unit.
Insert a disc with the label surface down. Doing so may damage the unit.
Label
surface up
NOTE:
. Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
.Handle the disc by its edge. And to keep the disc clean, do not touch
the surface.
.Do not stick paper or tape on the disc.
.Do not expose the disc to direct sunlight or heat sources such as hot air
ducts. Or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
Loading...